Pinnacle Abbington Custom Wood Blinds Installation Instructions

1
2 / ˝ Blind Installation
2
Spacer Blocks
1
The slat on a 2 / ˝ blind extends beyond the
2
back of the headrail. Spacer blocks must be
used for all outside mount applications (Fig. 6).
For inside mount applications
Spacer Blocks
there must be a minimum of
1
/ ˝ between the back
4
of the headrail and
any obstruction.
Tilt Wand
Attachment
Attach wand tip over
the end of the tilter
hook (Fig. 7).
(Fig. 7)
Valance Attachment
Blinds will be shipped with valance clips (Fig. 8).
Important: Valances Clips must be attached
to headrail before installing the blind.
Valance Clip
(Fig. 8)
If using returns attach returns to valance.
Then snap valance into clips
Pinnacle Cordless Blind Installation Instructions - 2024
5
Hold Down
Brackets
Hold Down Bracket fits
into predrilled hole in the
bottom rail to secure
the bottom rail in
place (Fig. 9).
(Usually used
on door blinds.)
(Fig. 6)
Care and Cleaning
Dusting
Wood blinds should be dusted regularly. Use a
soft, clean cloth or dusting mitt. Lower the blind
to its full length, tilt the slats almost all the way
down and dust. Then tilt the blinds almost all
the way up and dust. Not fully closing the slats
allows dusting where the slats overlap.
Vacuuming
Blinds may also be cleaned by vacuuming with
the brush attachment of a vacuum cleaner, tilting
the blinds up and down as described.
Important: Ultrasonic cleaning of wood blinds
is not recommended.
Valance
Pinnacle Cordless Blind Installation Instructions - 2024
(Fig. 9)
®
Blinds & Shades
6
Blinds & Shades
Pinnacle Cordless Blind
Installation Instructions
Abbington Custom Wood Blinds
Camden Custom Faux Wood Blinds
Pinnacle Cordless Blind Installation Instructions - 2024
1
®