Dell Dimension 2100 Solution Manual page 72

72
Adding Parts
Connect a power cable to the drive.
11
NOTICE:
When you attach the extra connector to the new drive in the
following step, match the colored strip on the cable with pin 1 on the drive.
If you didn't install a controller card in step 10, remove the tape from
12
the wide cable connector and reattach the connector to the original
drive. Then locate the extra connector on the cable and attach it to the
new drive. Be sure that the wide cable is properly connected to the
IDE connector on the system board.
If you installed a controller card in step 10, attach the other end of the
interface cable to the controller card rather than to the system board.
pin 1
cable
power cable from
power supply