Unattended Installation - Compaq BL10e - HP ProLiant - 512 MB RAM Supported Configurations

Install Version 7.70A (or later) of the ProLiant Support Pack (PSP) for Microsoft Windows Server
7.
2003 SP2, which is available at www.hp.com/cgi-bin/hpsupport/index.pl. The PSP contains
numerous files. For the PSP to be installed properly, all files must be present in the same directory
as the SETUP.EXE program.
Primary installation method
a.
Run the SETUP.EXE program included with the PSP. By default, all software components
o
are selected for installation. In most circumstances, this default selection should not be
altered.
Click Install to proceed with the installation. Although all software components are
o
selected for installation by default, only those required by the server will be installed. After
the installation is complete, the utility will display successfully installed components, non-
applicable components, and any component installation failures.
Command prompt installation
b.
Use the SETUPC.EXE to install the PSP from a command line prompt without user
o
interaction. This utility is designed as a tool that can be scripted. As with the SETUP.EXE
program, all components appropriate for the target server will be installed.
For additional usage information, refer to the BPXXXXXX.TXT file included with the
o
downloaded files and the ProLiant Support Pack and Deployment Utilities User Guide
posted on the download Web page for the PSP.

Unattended installation

For detailed procedures on unattended installs, refer to Microsoft documentation. When using an
UNATTEND.TXT file, follow these additional procedures.
If the UNATTEND.TXT file has the OEMPreinstall flag set, add the following line in the unattend
1.
section.
[UNATTEND]
DisableVirtualOemDevices=Yes
Ensure that any special hardware-specific drivers appropriate for your ProLiant server are
2.
available in the specified OEMFilesPath. The drivers for the supported devices may not be
included on the base media.
NOTE:
These changes are only necessary when using an
UNATTEND.TXT file with the OEMPreinstall flag set. Failure to
set this flag could cause installs to abort with the following
message: "File [filename] could not be loaded. Error code is
18. Setup cannot continue."
26