Gainsborough M303 Instructions For Use Manual

40 LED solar diamond string light
Item codes: M303/ 611920
Instructions for Use
Please read and retain these instructions for future reference
Power Details:
AA battery (Rechargeable)
1.2v 600Mah, Ni-MH.
Please read this instruction manual thoroughly before starting and ensure you are familiar with the
operation of your new 40 LED solar diamond string light.
BEFORE FIRST USE:
Remove the protective film from the solar panel.
CHARGING AND OPERATION:
1. Set switch (located on the back of solar case) to "S (steady on)" OR "F (flash)" position. Charge the
solar product by placing it under direct sunlight for at least 8 hours.
2. The light will work automatically. It will automatically charge under direct sunlight during the day
time and illuminate at night.
NOTE: In order to verify that the switch is correctly in the "S" OR "F" position, cover the solar panel with
your hand and the light should turn on automatically.
IMPORTANT:
1. Install the solar product in an area where it can get direct sunlight.
2. Leave the switch to "S" OR "F" position.
3. Select an outdoor location away from other light sources at night, such as street lights. It may
cause the product not to turn on automatically at night.
4. Duration of light depends on solar product's level of sunlight exposure, geographical locations,
weather conditions and the hours of daylight.
WARNINGS AND SAFETY INSTRUCTIONS:
WHEN USING ANY APPLIANCE, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED:
•
READ ALL INSTRUCTIONS BEFORE USE.
•
FOR DOMESTIC OUTDOOR USE.
•
NOT FOR COMMERCIAL USE.
•
BEFORE USE, CHECK THOROUGHLY FOR ANY DEFECTS AND DO NOT USE IF DEFECTS ARE FOUND. TAKE
CARE NOT TO DROP THE APPLIANCE AS HEAVY IMPACTS MAY CAUSE INTERNAL DAMAGE.
v001: 20/12/23
ENGLISH INSTRUCTIONS
ALWAYS USE ALKALINE BATTERIES.
DO NOT USE LITHIUM BATTERIES.