If You Are Using A Linux Server - Dell PowerVault 3000i System Installation Manual

Modular disk system
Table of Contents

Advertisement

To view active sessions to the target, use the following command:
iscsicli SessionList
To support storage array controller failover, the host server must be connected to at least one iSCSI
port on each controller. Repeat step 3 for each iSCSI port on the storage array that you want to
establish as a failover target. (The Target_Portal_Address will be different for each port you
connect to).
PersistentLoginTarget does not initiate a login to the target until after the system is rebooted.
To establish immediate login to the target, substitute LoginTarget for
PersistentLoginTarget.
NOTE:
Refer to the Microsoft iSCSI Software Initiator 2.x User's Guide for more information about the
commands used in the previous steps. For more information about Windows Server 2008 Server Core, refer to
the Microsoft Developers Network (MSDN). Both resources are available at www.microsoft.com.

If you are using a Linux Server

If you configured CHAP authentication in the previous steps, you must restart iSCSI from the Linux
command line as shown below. If you did not configure CHAP authentication, you do not need to restart
iSCSI.
/etc/init.d/iscsi restart
Verify that the host server is able to connect to the storage array by running the iscsi -ls command as you
did in target discovery. If the connection is successful, an iSCSI session will be established to each iSCSI
port on the storage array.
Sample output from the command should look similar to this:
*******************************************************************************
SFNet iSCSI Driver Version ...4:0.1.11-3(02-May-2006)
*******************************************************************************
TARGET NAME
TARGET ALIAS
HOST ID
BUS ID
TARGET ID
TARGET ADDRESS
SESSION STATUS
SESSION ID
*******************************************************************************
TARGET NAME
TARGET ALIAS
HOST ID
BUS ID
TARGET ID
TARGET ADDRESS
56
Setting Up Your iSCSI Storage Array
: iqn.1984-05.com.dell:powervault.6001372000f5f0e600000000463b9292
:
: 2
: 0
: 0
: 192.168.0.110:3260,1
: ESTABLISHED AT Wed May
: ISID 00023d000001 TSIH 5
: iqn.1984-05.com.dell:powervault.6001372000f5f0e600000000463b9292
:
: 3
: 0
: 0
: 192.168.0.111:3260,1
9 18:20:27 CDT 2007

Advertisement

Table of Contents
loading

This manual is also suitable for:

Powervault md3000i

Table of Contents