4 Turn on attached units:
Turn on the MD1000 expansion enclosure(s). Wait for the enclosure status LED to light blue.
a
Turn on the MD3000i and wait for the status LED to indicate that the unit is ready:
b
•
If the status LEDs light a solid amber, the MD3000i is still coming online.
•
If the status LEDs are blinking amber, there is an error that can be viewed using the
MD Storage Manager.
•
If the status LEDs light a solid blue, the MD3000i is ready.
After the MD3000i is online and ready, turn on any attached host systems.
c
5 Using the MD Storage Manager, update all attached MD1000 firmware if it is out of date:
Select Support→ Download Firmware→ Download Environmental (EMM) Card Firmware.
a
Check the Select All check box so that all attached MD1000 enclosures are updated at the same
b
time (each takes approximately 8 minutes to update).
18
Hardware Installation