Feet Installation; Logo Plate - Compaq 141536-002 - Deskpro EN - MT RAMBUS Maintenance And Service Manual

Convertible minitower models

Hide thumbs Also See for 141536-002 - Deskpro EN - MT RAMBUS:

Table of Contents

4.3

Feet Installation

Four (4) rubber feet are mounted to the chassis, as shown below. No parts have to be

removed to access the feet. The replacement feet have an adhesive surface and are shipped

with a protective backing in place. Remove the backing from the feet before installation.

If necessary, remove the old feet and remove any adhesive residue from the chassis.

4.4

Grasp the open side of the logo plate (left side if a desktop, bottom if a minitower) and

pull outward 2.

To install a new logo plate, align the guide pins in the slots 1, then press into place.

✎

When replacing the logo plate, ensure that the alignment pins are properly placed

in the front bezel before pressing the logo plate into position.

Compaq Deskpro EN Series of Personal Computers

4-3

Table of Contents