Compaq 141536-002 - Deskpro EN - MT RAMBUS Maintenance And Service Manual page 57

10. Press in on the tabs to release the vertical drivelock from the chassis, then lift it up and
out of the system while at the same time rotating the drivelock slightly to clear the
travel slots at the bottom of the drivelock.
11. Remove the spring from the post (see inset).
To reinstall the vertical drivelock, reverse the previous procedure.
To reinstall the horizontal drivelock:
1. Insert the left side of the drivelock (with the rounded tabs) into the slots on the
drive cage.
2. Place the washer on the middle tab on the underside of the drivelock.
3. Compress the spring, then lower the drivelock onto the drive cage until it snaps
into place.
4-20 Removal and Replacement Procedures