Asus V6-P5G41E User Manual page 46

3. IDE connector (40-1 pin PRI_IDE)
The onboard IDE connector is for the Ultra DMA 100/66 signal cable. There
are three connectors on each Ultra DMA 100/66 signal cable: blue, black, and
gray. Connect the blue connector to the motherboard's IDE connector, then
select one of the following modes to configure your device.
Single device
Two devices
•
•
If any device jumper is set as "Cable-Select," ensure that all other device
jumpers have the same setting.
P5G41T-M LX2/GB
P5G41T-M LX2/GB IDE connector
3-6
Drive.jumper.setting
Cable-Select or Master
Cable-Select
Master
Slave
Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.
PIN1
Mode of
device(s)
Master
Slave
Master
Slave
PRI_IDE
NOTE:Orient the red markings
on the IDE ribbon cable to PIN 1.
Cable.connector
- Black
Black
Gray
Black or gray
Chapter 3: Motherboard info