Subscribe to Our Youtube Channel
Related Manuals for HBX WAV-0210
Summary of Contents for HBX WAV-0210
- Page 1 Installation Manual WAV-0210 WAV-0211 WAV-0212 Version 1.00 WAV-0210 WAV-0211 WAV-0212 HBX Control Systems Inc. Page 1...
-
Page 2: Table Of Contents
Control Systems Inc. H B X W A V - 0 2 1 0 W i r e l e s s O u t d o o r S e n s o r V e r s i o n 1 . 0 Table of Contents •... -
Page 3: Introduction
SAFETY SYMBOLS AND WARNINGS: Storage Extreme Hazard - The WAV-0210 should be kept in its original shipping This action poses a serious threat that could carton prior to installation. In order to retain the result in personal injury or death, as well warranty coverage it should be stored properly: as permanent damage to the equipment. -
Page 4: Description
Description The HBX WAV-0210 Control is designed to be a microprocessor based outdoor wireless sensor system. It is easy to install, requiring minimal wiring for simple installation. The weather resistant sensor is reliable and has a minimum two year battery life. -
Page 5: Technical Data And Dimensions
Signal Power Bottom View 24 VAC GND THERM OUT 24 VAC GND THERM OUT 43 mm 78 mm 78 mm 76 mm Outdoor Sensor - Inside View Indoor Sensor - Inside View © HBX Control Systems Inc. 2017 Page 5... -
Page 6: Wiring And Installation
*Default Setting Make sure to wire the thermistor section to the control AFTER powering the WAV-0210. • Connect 18 AWG or similar wire to the THERM OUT terminals in the base and run the wire from here to the outdoor sensor control terminal. -
Page 7: Initial Setup And Pairing
24 VAC GND THERM OUT 24 VAC GND THERM OUT Green LED Red LED Max 1ft Base Unit Outdoor Unit 24 VAC GND THERM OUT FIG 7 FIG 5 Base Unit Outdoor Unit © HBX Control Systems Inc. 2017 Page 7... -
Page 8: Mounting The Outdoor Unit
H B X W A V - 0 2 1 0 O u t d o o r W i r e l e s s S e n s o r V e r s i o n 1 . 0 Mounting the Outdoor Unit • The HBX WAV-0210 can be mounted directly onto a 1 ft wall. -
Page 9: Changing The Batteries
Step 3. for more than 3 hours. Step 3 When the WAV-0210 is in this mode, the base unit will output a resistance for 0°F on the control it has been Try powering down the outdoor sensor by taking out one connected to. -
Page 10: Thermistor Output Curves
• Laars Neotherm • Uponor CCN • IBC SL, VFC • Viessmann • Taco iWorx (excluding Vitodens-100W) • Slant/Fin CHS • HBX Controls • Lochinvar • NTI Trinity & Vmax • Camus • Raypak • ATH • RBI • Navien •... -
Page 11: Wiring Examples
V e r s i o n 1 . 0 WAV-0210 with Optional External Sensor connected to THM-0100 On the outdoor unit control board, there is an external thermistor input beside the pairing button. When not using an external sensor, the control will use a built in thermistor. -
Page 12: Limited Warranty
HBX Controls warrants each of its products to be free from defects in workmanship and materials under normal use and service for a period of 24 months from date of manufacture or 12 months from date of purchase from an HBX Authorized Dealer, if within the above documented period after date of manufacture. - Page 13 H B X W A V - 0 2 1 0 O u t d o o r W i r e l e s s S e n s o r V e r s i o n 1 . 0 Notes © HBX Control Systems Inc. 2017 Page 13...
- Page 14 H B X W A V - 0 2 1 0 O u t d o o r W i r e l e s s S e n s o r V e r s i o n 1 . 0 Notes Page 14...
- Page 15 H B X W A V - 0 2 1 0 O u t d o o r W i r e l e s s S e n s o r V e r s i o n 1 . 0 © HBX Control Systems Inc. 2017 Page 15...
- Page 16 Phone: +1 (403) 720-0029 Fax: +1 (403) 720-0054 Email: inf o @ hbxcontrols.com Web: www.hbxcontrols.com Toll Free Technical Support: +1 (855) 554 6629 HBX Control Systems Inc. 4516 - 112 Avenue SE © HBX Control Systems Inc. 2017 Calgary, AB Canada T2C 2K2 Page 16...
Need help?
Do you have a question about the WAV-0210 and is the answer not in the manual?
Questions and answers