Leviton decora OSSMT-MQ Installation Instructions

WARNINGS AND CAUTIONS:
DISCONNECT POWER AT CIRCUIT BREAKER OR FUSE WHEN SERVICING, INSTALLING OR REMOVING FIXTURE.
DO NOT
TOOLS NEEDED TO INSTALL YOUR SENSOR
FEATURES
®
DESCRIPTION
Cat.No. OSSMT-MQ is UL listed. Cat. No. OSSMT-GQ is ETL listed
and cETL listed.
(refer to
Field-of-View diagrams).
Multi-Technology Designer Wall Switch Occupancy Sensor
Incandescent/Tungsten:
It is recommended to mount the Occupancy
Sensor at least 6 feet away from a climate control source.
INSTALLING YOUR SENSOR
NOTE:
WARNING:
TO AVOID FIRE, SHOCK, OR DEATH; TURN
Step 1
OFF POWER
Identifying your wiring application
Step 2
(most common):
2
1
2
1
3
3
4
4 5
Single-Pole 3-Way
1. 1.
2.
NOTE: 2.
3. NOTE:
4. 3.
4.
5.
Note:
IMPORTANT:
Cat. No. OSSMT-MQ & OSSMT-GQ
Ballast: Ballast:
Operating Temperature Range:
Relative Humidity:
No Minimum Load Required
INSTALLATION INSTRUCTIONS
WARNINGS AND CAUTIONS:
WITH COPPER OR COPPER CLAD WIRE ONLY
Preparing and connecting wires:
Step 3
Strip Gage
9/16"
(measure bare
(1.4 cm)
wire here)
Cut
(if necessary)
straight
(cut if necessary)
Installing your Sensor – Single-Pole Application:
Step 4
NOTE:
NOTE:
Wiring Diagram for OSSMT-MQ
Blue
Black
Black (Hot) Black
White
Load
Line
120-277V, 50/60Hz
Green
Ground White
Neutral (White)
WIRING SENSOR:
Connect wires per WIRING DIAGRAM as follows:
NOTE: Allow 1 minute for warm-up after connecting and energizing.
Motor:
Installing your Sensor – Multi-location Wiring
Step 5
Application:
NOTE:
OSSMT-GQ Multi-Location Wiring Diagram
Sensor 1 Sensor 2
Black (Hot) Black Blue Blue Black
Black
Line
120-277V, 50/60Hz
Load
Green Green
White
Ground Ground
Neutral (White)
OSSMT-MQ Multi-Location Wiring Diagram
Sensor 1 Sensor 2
Black (Hot) Black
Blue Blue Black
Black
White White
Line
120-277V, 50/60Hz
Load
Green Green
Ground Ground White
Neutral (White)
must
NOTE:
must
NOTE:
WIRING SENSOR 1:
Connect wires per WIRING DIAGRAM as follows:
WIRING SENSOR 2:
Connect wires per WIRING DIAGRAM as follows:
NOTE: Allow 1 minute for warm-up after connecting and energizing.
Testing your Sensor prior to completely
Step 6
mounting in wall box:
Wall surface
Mounting
screws
(2 places)
Sensor
NOTE:
NOTE: Allow 1 minute for warm-up after energizing.
NOTE:
(refer
to FEATURES section).
(refer to the SETTINGS section).
NOTE:
(refer to Control Panel
Diagram).
NOTE: DO NOT
(refer to Control Panel Diagram).
If lights do not turn ON, refer to the TROUBLESHOOTING section.
FEATURES
NOTE: To access control settings, remove the control panel cover.
If necessary, remove the warning label that covers the adjustment
dials (refer to Control Panel Diagram).
Factory Settings:
Blinders:
(refer to Control Panel Diagram)
Time-Outs:
Adapting Time-Out:
Walk-through Time-Out: