Universal Setup Menu - Dell Laser Printer 2230d User Manual

Universal Setup menu

These menu items are used to specify the height, width, and feed direction of the Universal Paper Size. The Universal
Paper Size is a user-defined paper size. It is listed with the other paper size settings and includes similar options, such
as support for duplex printing and printing multiple pages on one sheet.
Menu item
Units of Measure
Inches
Millimeters
Portrait Width
3–14.17 inches
76–360 mm
Portrait Height
3–14.17 inches
76–360 mm
Feed Direction
Short Edge
Long Edge
Description
Identifies the units of measure
Notes:
•
Inches is the US factory default setting.
•
Millimeters is the international factory default setting.
Sets the portrait width
Notes:
•
If the width exceeds the maximum, then the printer uses the
maximum width allowed.
•
8.5 inches is the US factory default setting. Inches can be increased
in 0.01-inch increments.
•
216 mm is the international factory default setting. Millimeters can
be increased in 1-mm increments.
Sets the portrait height
Notes:
•
If the height exceeds the maximum, then the printer uses the
maximum height allowed.
•
14 inches is the US factory default setting. Inches can be increased in
0.01-inch increments.
•
356 mm is the international factory default setting. Millimeters can
be increased in 1-mm increments.
Specifies the feed direction
Notes:
•
Short Edge is the factory default setting.
•
Long Edge appears only if the longest edge is shorter than the
maximum length supported in the tray.
Understanding the printer menus
21