Setting Surface Controls - Kenmore 3050 - Pro 36 in. Gas Slide-In Cooktop Use And Care Manual

Setting Surface Controls
Sizes of the Surface
Gas Burners
Your appliance is supplied with
the following 5 different
surface gas burners:
• 1 Simmer Burner
(5,000 BTU)
= 2 Standard Burners
(9,500 BTU)
• 1 Triple Ring Burner
(3,000 & 13,000 BTU)
• 1 Power Burner
(12,200 BTU)
• 1 Power Burner
(17,200 BTU)
When setting up the range for
the first time, make sure that the
correct Burner Heads, Burner
Caps and Burner Grates are
located as shown in Figure 1.
Burner Cap Standard
Triple Ring (Standard).,.. .... Burner Head
Small Burner C_ _ _ .(9,500 BTU)
Triple Ring _ _Left Rear Burner Can
Large Burner Ca_ Gas Openin ,_ t ..... _r
ead not removab e (9,500 BTU) Small
Burner Cap
(3,000 & 13,000 BTU),,POWER,,_ Cent ar _.,_, "SIMMER"
Burner Head_ Gas Opening _ Burner Head
(12,200 BTU)I _ (5.000 BTU
OWER"
_""_*_ Right Rear
Center Front Burner Head _c _Gas O_enin
GasOpening (17.200BTU - _'_ Extra Large- _" g
urner CaD
t Figure 1
Gas Opentng
Burner
Grate _
Burner
Cap
Burner
Head
Gas
upentng
Electrode must be
located properly in slot of
each Burner Head
Figure 2
Assembly
of the Surface Burner
Heads, Burner Caps,
Burner Grates and Flue Covers
It is very important to make sure that all of the Surface Burner Heads,
Surface Burner Caps and Surface Burner Grates are installed correctly
and at the correct locations.
1. Place all Burner Heads in the correct locations (See Figure 1).
Make sure that the correct Burner Head is placed with the
corresponding Gas opening and that the Electrode is located
properly in the slot of each Burner Head (See Figure 2). Proper
Burner Head placement insures that each Burner will have the
correct spark required for surface gas ignition.
2. Place the correct Burner Caps at each of the burner locations.
Each of the 4 (four) Burner Heads MUST have a Burner Cap
installed to insure proper ignition and gas flame size and must be
in place BEFORE placing the Burner Grates (See Figure 2).
3. Place the 3 cast iron Burner Grates supplied with the range.
Carefully lift the burner grates onto the cooktop over the burners.
Properly installed Burner Grates will rest with all Grate legs on the
cooktop.
REMEMBER -- DO NOT ALLOW SPILLS, FOOD, CLEANING
AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS
OPENING. Always keep the Burner Caps and Burner Heads in place
whenever the surface burners are in use.