Quadra-Fire EXPEDITION-AU Installation Manual
Quadra-Fire EXPEDITION-AU Installation Manual

Quadra-Fire EXPEDITION-AU Installation Manual

Expedition i wood insert automatic combustion control (acc)

Advertisement

Quick Links

E. Power Cord
The power cord is shipped assembled to the appliance.
You may route the power cord either to the left or right
side depending on your configuration for power source
INSTALLER: Leave this manual with party responsible for use and operation.
(Figure 20.1). NOTE: Power cord is 96 inches in length.
OWNER: Retain this manual for future reference.
EXPEDITION I WOOD INSERT
AUTOMATIC COMBUSTION
CONTROL (ACC)
MODEL NUMBER:
EXPEDITION-AU
Figure 20.1
F. Flat Surround
Overall Dimensions
Small Size
38" x 28"
Standard Size
43" x 31"
1. Lay surround face down on a protected surface to
prevent scratching.
2. Remove door from front of appliance and set aside laying
it onto a protective surface (Figure 20.2).
3. Remove face from front of appliance and set aside laying
it onto a protective surface (Figure 20.2).
4. Lift surround to front of appliance (Figure 20.3).
5. Reinstall face to front of appliance and then the door.
11/23
1
20
Installation Manual
Installation & Appliance Set-Up
NOTICE: DO NOT DISCARD THIS MANUAL
Part Number
SP1-3828
SP1-4331
R
If the information in these instructions
causing property damage, personal injury,
or death.
Figure 20.2
• Do not
store
or use gasoline or other
and liquids in the vicinity of this or any other appliance.
• Do not over
you are over
• Comply with all minimum clearances to combustibles
as
Failure to comply may cause house
Hot glass and appliance will cause burns.
• Do not touch glass until it is cooled
• Use leather gloves when reloading fuel
• NEVER allow children to touch glass
• Keep children away
• CAREFULLY SUPERVISE children in same room
as appliance.
Figure 20.3
• Alert
children
high temperatures
• High temperatures may ignite clothing or other
materials.
• Keep
clothing,
materials away.
Fire Risk.
For use with solid wood fuel only.
Other fuels may over
poisonous gases (i.e. carbon monoxide).
NOTE: To obtain a French translation of this manual,
please contact your dealer or visit
REMARQUE : Pour obtenir une traduction française de
ce manuel, s'il vous plaît contacter votre revendeur ou
visitez
7094-802E
7094-802E
WARNING
- If heater or chimney connector glows,
Over
will void your warranty.
WARNING
HOT SURFACES!
Glass and other surfaces are hot during
operation AND cool down.
and
adults
to
furniture,
draperies
WARNING
vapors
hazards
of
and
other
and generate
11/23
11/23
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EXPEDITION-AU and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Quadra-Fire EXPEDITION-AU

  • Page 1 - If heater or chimney connector glows, MODEL NUMBER: you are over Over will void your warranty. • Comply with all minimum clearances to combustibles EXPEDITION-AU Figure 20.1 Failure to comply may cause house F. Flat Surround WARNING Overall Dimensions...
  • Page 2: Table Of Contents

    F. Chimney Height / Rise and Run ..........14 G. Securing Chimney Components ..........14 H. Larger Chimneys..............15 I. Masonry Chimney..............15 J. Metal Heat Circulating Masonry..........16 K. Prefabricated Metal Chimney ..........16 L. Ovalizing Round Stainless Steel Liners........17 M. Altering the Fireplace .............17 Quadra-Fire is a registered trademark of Hearth & Home Technologies. 7094-802E 7094-802E 7094-802E 11/23 11/23 11/23...
  • Page 3: Important Safety Information

    E. Power Cord Important Safety Information The power cord is shipped assembled to the appliance. You may route the power cord either to the left or right A. Insert Safety Certification C. BTU & Efficiency Specifications side depending on your configuration for power source (Figure 20.1).
  • Page 4: Mobile Home Approved (Usa Only)

    D. Mobile Home Approved (USA only) E. Power Cord E. Power Cord K. California - Prop65 • This appliance is approved for mobile home installations The power cord is shipped assembled to the appliance. The power cord is shipped assembled to the appliance. WARNING when not installed in a sleeping room and when an You may route the power cord either to the left or right...
  • Page 5: Getting Started

    E. Power Cord Getting Started The power cord is shipped assembled to the appliance. You may route the power cord either to the left or right A. Design and Installation Considerations B. Draft side depending on your configuration for power source (Figure 20.1).
  • Page 6: Negative Pressure

    C. Negative Pressure E. Power Cord E. Power Cord D. Tools And Supplies Needed The power cord is shipped assembled to the appliance. The power cord is shipped assembled to the appliance. Before beginning the installation be sure the following tools WARNING You may route the power cord either to the left or right You may route the power cord either to the left or right...
  • Page 7: Standard Size 43" X 31" Sp1-4331

    F. Install Checklist E. Power Cord The power cord is shipped assembled to the appliance. You may route the power cord either to the left or right ATTENTION INSTALLER: side depending on your configuration for power source Follow this Standard Work Checklist (Figure 20.1).
  • Page 8: Dimensions And Clearances

    E. Power Cord E. Power Cord Dimensions and Clearances The power cord is shipped assembled to the appliance. The power cord is shipped assembled to the appliance. You may route the power cord either to the left or right You may route the power cord either to the left or right A.
  • Page 9 E. Power Cord 12-1/8” 11-3/8” The power cord is shipped assembled to the appliance. (309 mm) (290 mm) You may route the power cord either to the left or right side depending on your configuration for power source (Figure 20.1). NOTE: Power cord is 96 inches in length. 19-3/4”...
  • Page 10: Clearances To Combustibles

    E. Power Cord E. Power Cord B. Clearances to Combustibles The power cord is shipped assembled to the appliance. The power cord is shipped assembled to the appliance. You may route the power cord either to the left or right You may route the power cord either to the left or right As tested to appendix b of AS/NZS 2918 side depending on your configuration for power source...
  • Page 11 E. Power Cord How to Determine if Alternate Floor Protection Materials CAUTION are Acceptable The power cord is shipped assembled to the appliance. You may route the power cord either to the left or right All floor protection must be noncombustible (i.e. metals, brick, Hearth and Home Technologies does not recommend adhesive side depending on your configuration for power source based vinyl flooring due to thermal expansion. Floating-style stone, mineral fiber boards, etc.). Any organic materials (i.e.
  • Page 12: Locating Your Stove & Chimney

    E. Power Cord E. Power Cord Chimney Systems The power cord is shipped assembled to the appliance. The power cord is shipped assembled to the appliance. You may route the power cord either to the left or right You may route the power cord either to the left or right A.
  • Page 13: It Onto A Protective Surface (Figure 20.2)

    B. Chimney Termination Requirements E. Power Cord NOTICE: Locating the appliance in a basement or in Follow manufacturer’s instructions for clearance, securing The power cord is shipped assembled to the appliance. a location of considerable air movement can cause flashing and terminating the chimney (Figure 13.1 and You may route the power cord either to the left or right intermittent smoke spillage from appliance. Do not locate appliance near...
  • Page 14: Venting Systems

    D. Venting Systems E. Power Cord E. Power Cord WARNING Chimney Connector - It is also known as flue pipe or The power cord is shipped assembled to the appliance. The power cord is shipped assembled to the appliance. stove pipe. It must be 6 inches (152mm) minimum diameter You may route the power cord either to the left or right You may route the power cord either to the left or right Asphyxiation Risk.
  • Page 15: Ovalizing Round Stainless Steel Liners

    L. Ovalizing Round Stainless Steel Liners E. Power Cord WARNING Ovalizing round stainless steel liners to accommodate the The power cord is shipped assembled to the appliance. liner passing through the damper region of a fireplace is an You may route the power cord either to the left or right Asphyxiation Risk. allowable and acceptable practice. side depending on your configuration for power source DO NOT connect this appliance to a chimney (Figure 20.1).
  • Page 16: Appliance Set-Up

    E. Power Cord E. Power Cord Appliance Set-Up The power cord is shipped assembled to the appliance. The power cord is shipped assembled to the appliance. You may route the power cord either to the left or right You may route the power cord either to the left or right A.
  • Page 17: Stove Pipe Or Liner To Flue Collar

    F. Flat Surround Optional use of a Simpson Duravent 15° Universal Elbow Part Number 4615 may be purchased directly through your Overall Dimensions Part Number local Simpson Duravent Pipe Distributor or from your local Quadra-Fire dealer, Part Number DV-6DLR-E15ADSS. Small Size 38” x 28” SP1-3828 5/16 Bolts Figure 19.2 shows a vertical installation and also how to Standard Size 43”...
  • Page 18 E. Power Cord E. Power Cord E. Power Cord The power cord is shipped assembled to the appliance. The power cord is shipped assembled to the appliance. The power cord is shipped assembled to the appliance. You may route the power cord either to the left or right You may route the power cord either to the left or right You may route the power cord either to the left or right side depending on your configuration for power source...
  • Page 19: Flat Surround With Trim Kit

    G. Flat Surround with Trim Kit E. Power Cord 5. Install two steel springs at the top on each side and between the flat surround and the assembled trim kit as The power cord is shipped assembled to the appliance. Overall Part shown in Figure 21.3 Trim Kit You may route the power cord either to the left or right Dimensions Number side depending on your configuration for power source...
  • Page 20: Standard Surround & Cast Trim Kit

    H. Standard Surround & Cast Trim Kit E. Power Cord E. Power Cord 6. Place the cast footers under the metal sides aligning the top and bottom holes in the cast footers and metal sides. The power cord is shipped assembled to the appliance. The power cord is shipped assembled to the appliance. Overall Dimensions Part Number 7.
  • Page 21: Reference Materials

    E. Power Cord Reference Materials The power cord is shipped assembled to the appliance. You may route the power cord either to the left or right A. Wiring Harness side depending on your configuration for power source Service Part: SRV7000-891 (Figure 20.1).
  • Page 22: Service And Maintenance Log

    C. Service and Maintenance Log E. Power Cord E. Power Cord The power cord is shipped assembled to the appliance. The power cord is shipped assembled to the appliance. Date of Service Performed By Description of Service You may route the power cord either to the left or right You may route the power cord either to the left or right side depending on your configuration for power source side depending on your configuration for power source...
  • Page 23 E. Power Cord Date of Service Performed By Description of Service The power cord is shipped assembled to the appliance. You may route the power cord either to the left or right side depending on your configuration for power source (Figure 20.1).
  • Page 24 E. Power Cord E. Power Cord Date of Service Performed By Description of Service The power cord is shipped assembled to the appliance. The power cord is shipped assembled to the appliance. You may route the power cord either to the left or right You may route the power cord either to the left or right side depending on your configuration for power source side depending on your configuration for power source...
  • Page 25 E. Power Cord Date of Service Performed By Description of Service The power cord is shipped assembled to the appliance. You may route the power cord either to the left or right side depending on your configuration for power source (Figure 20.1).
  • Page 26 E. Power Cord E. Power Cord Date of Service Performed By Description of Service The power cord is shipped assembled to the appliance. The power cord is shipped assembled to the appliance. You may route the power cord either to the left or right You may route the power cord either to the left or right side depending on your configuration for power source side depending on your configuration for power source...
  • Page 27 E. Power Cord Zero Clearance Installation using approved ZC box The power cord is shipped assembled to the appliance. You may route the power cord either to the left or right side depending on your configuration for power source (Figure 20.1). NOTE: Power cord is 96 inches in length. Figure 20.2 Figure 20.1 F.
  • Page 28: Contact Information

    E. Power Cord E. Power Cord The power cord is shipped assembled to the appliance. The power cord is shipped assembled to the appliance. You may route the power cord either to the left or right You may route the power cord either to the left or right side depending on your configuration for power source side depending on your configuration for power source (Figure 20.1).

Table of Contents