GENERATOR START - UP PROCEDURE ( MANUAL ) BEFORE STARTING WARNING CAUTION DO NOT operate this equipment without first reading and understanding all relevant safety information. Refer The engine’s exhaust contains harmful emissions. to the Safety Information section in the operation ALWAYS have adequate ventilation when operating.
Page 3
GENERATOR START - UP PROCEDURE ( MANUAL ) STARTING (MANUAL) 4. Make sure the Circuit Breaker OFF button LED is ON (red). See Figure 3. 1. To start the engine, press the Run button (Figure 6) on the digital controller. Figure 3.
Page 4
GENERATOR START - UP PROCEDURE ( MANUAL ) 3. The controller display will indicate the 60-cycle output 9. Press the Circuit Breaker ON button (Figure 9). frequency in HERTZ (Figure 7C). The button LED will turn ON (green) and power will be supplied to the output terminals, cam-loks, and receptacles.
GENERATOR START - UP PROCEDURE ( AUTO MODE ) STARTING (AUTO MODE) When starting the generator in Auto mode use the manual start-up procedure except where noted (see below). DANGER 1. Perform steps 1 through 6 in Before Starting found in Before connecting this generator to any the Generator Start-Up Procedure (Manual) section.
GENERATOR SHUTDOWN PROCEDURE NORMAL SHUTDOWN PROCEDURE (MANUAL) NORMAL SHUTDOWN PROCEDURE (AUTO) 1. Open the remote-start contacts. The circuit breaker will WARNING automatically turn OFF and the engine will stop after a NEVER stop the engine suddenly except in an 1-minute cool-down process. emergency.
Need help?
Do you have a question about the WHISPERWATT DCA300SSJU4F3PB and is the answer not in the manual?
Questions and answers