VEVOR K1E01017 Manual
VEVOR K1E01017 Manual

VEVOR K1E01017 Manual

Dog grooming tub
Hide thumbs Also See for K1E01017:

Advertisement

MODEL: K1E01017/K1E01018
IMPORTANT SAFEGUARDS
WARNING: Read and understand this entire manual before
operating or servicing this product. Failure to follow these
warnings and instructions can cause personal injury or
damage to valuable property.
 Avoid children using grooming tub. And this product is not a toy. Do not
allow children to play.
 Keep away from sharp points,blades and other items.
 Assembly precautions
1. Assemble only according to these instructions. Improper assembly can
create hazards.
2. Wear ANSI-approved safety goggles and heavy-duty work gloves during
assembly.
3. Keep assembly area clean and well-lit.
4. Keep bystanders out of the area during assembly.
5. Do not assemble when tired or when under the influence of alcohol,
DOG GROOMING TUB

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the K1E01017 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for VEVOR K1E01017

  • Page 1 MODEL: K1E01017/K1E01018 DOG GROOMING TUB IMPORTANT SAFEGUARDS WARNING: Read and understand this entire manual before operating or servicing this product. Failure to follow these warnings and instructions can cause personal injury or damage to valuable property.  Avoid children using grooming tub. And this product is not a toy. Do not allow children to play.
  • Page 2: Preparations Before Installation

    drugs or medication. 6. Product capabilities apply to properly and completely assembled product only. 7. For additional information regarding the parts listed in the following pages, please refer to the Assembly Diagram of this manual. Unwrap and separate all parts in a clean work area. Please keep small spare parts out of children's reach.
  • Page 3 2 pcs 1 pc 1 pc 1 pc 3: Right side 4: Left side 1: H rack 2: Tub panel panel 1 pc 1 pc 1 pc 1 pc 5: Door 8: Faucet 7: Back panel (Already Installed to 6: Horizontal tube switch the tub) 1 pc...
  • Page 4 12 pcs 14 pcs (M6*16mm) 4 pcs (M8) 6 pcs (M6*35mm) 23: Hex flange 21: Screw 22: Screw 24: Washer 3 pcs 2 pcs 1 pc 1 pc 27: Sealing tape 28: Gloves 25: Stair board 26: Nut 6 pcs 1 pc 2 pcs 2 pcs...
  • Page 5 ① Install the adjustable feet to the H rack, and fix the h orizontal tube to the H rack Caution: Ensure that the depth of adjustable feet is not less than 12mm and try to make the four adjustable feet screw in the same depth.
  • Page 6 ③ Adjust the height of the feet to make sure the height of water outlet side is 1-2 degrees lower than the other side (use a spirit level to show). ④ Install the strainer, ensure that the sealing ring is free of dislocation and wrinkles.
  • Page 7 ⑦ Install door and put the water filter plate to the tub ⑧ Use screw to fix the stair board and ladder rod, then install the adjustable feet on the bottom of the ladder rod. Caution: Ensure that the depth of adjustable feet is not less than 12mm and try to make the two adjustable feet screw in the...
  • Page 8 ⑨ Install the stairs into the chassis rails ⑩ Use screw and hex flange nut to install the storage basket to the b ack panel ⑪ Use screw and hex flange nut to install the s hower bracket to the right-side panel...
  • Page 9 ⑪ Install hot and cold shower switch and water inlet. Caution: Before you do this, make sure that your water source is on the left or right side of the bathtub, and select the direction of installation of the tap switch. Step1: Pass straight all-copper connector through side panel (1/2“end facing outside), screw...
  • Page 10: Dimensions And Parameters

    DIMENSIONS AND PARAMETERS Left Door Right Door...
  • Page 11: Operation

    Model# L(mm) H(mm) H1(mm) H2(mm) W(mm) N.W. (kg) K1E01017 1220 29.7 K1E01018 1220 29.7 Volume Loading Capacity Recommended pet Model# (CBM) (Kg) (cm) K1E01017 0.35 L×W×H:84×40×45 K1E01018 0.35 L×W×H:84×40×45 OPERATION 1. Make sure the water pipe connection is complete and the water is flowing normally.
  • Page 12: Care Instructions

    the drain to avoid clogging. 3.Please clean the transparent cover of the drain regularly,After disassembly like a nut, it can be easily cleaned, and be careful not to leave the seal ring when installing it back. CARE INSTRUCTIONS Don't put the bathtub on an uneven surface. Don’t drop or mistreat the bathtub.

This manual is also suitable for:

K1e01018

Table of Contents