Table of Contents
Advertisement
Quick Links
Steam cleaner
Please read and keep these instructions
Quick start
1 Fill the tank up to a maximum of 0.75 litres of
water (using warm water will reduce the heat-up
time). Screw cap on and tighten fully.
2 Attach the hose and required accessories.
3 Connect to the power supply.
4 Press the on/off button to start heat-up. When
green light turns off, the steam is ready.
5 Press the trigger on the handle to release the
steam.
6 Aim the steam safely: at the start water may be
ejected. Hold over a sink or bucket until excess
water has cleared.
Descaling
Descale regularly, do not wait for a problem to
occur. In very hard water areas we recommend using
distilled water.
www.morphyrichards.com
Advertisement
Table of Contents
Related Manuals for Morphy Richards IB70445
Summary of Contents for Morphy Richards IB70445
- Page 1 Steam cleaner Please read and keep these instructions Quick start 1 Fill the tank up to a maximum of 0.75 litres of water (using warm water will reduce the heat-up time). Screw cap on and tighten fully. 2 Attach the hose and required accessories. 3 Connect to the power supply.
-
Page 2: Important Safety Instructions
Unprofessional repairs can be dangerous rules. for users. Primarily there is danger of injury or death • Use only genuine Morphy Richards spare and secondly the danger of damage to the parts and accessories. appliance. These are indicated in the text by •... - Page 3 fi fl › ‡ · ‚ ‹ „ ¤ ⁄ ‰ ı Â Ê Á Ë Ù È Í Ò Î Ô Ú Ï Ì Ó Û Features Accessories È Extension tubes x 3 ⁄ Shoulder strap Í Upholstery nozzle ¤...
-
Page 4: Fitting The Hose
Fitting the strap Clip the shoulder strap ⁄ to the two hooks › and adjust for comfort by sliding the strap length adjuster ‹. Fitting the hose Pull the hose inlet flap ‰ down, line up the locating keyway on the plug with the Quick accessory socket and push the hose connector firmly and fully into the cleaner socket B. - Page 5 Using prevents the filler cap being undone when there is steam pressure in the tank. This is shown by a red safety indicator which IMPORTANT: Please remember that the pushes out when there is steam pressure steam cleaner operates by emitting steam at inside the tank and goes back in again when an increased temperature of 130˚C.
- Page 6 Switching on 4 To stop the steam jet, release the steam trigger. 1 Insert the plug into the power socket. IMPORTANT: Do not hold the steam jet 2 Switch the cleaner on by pressing the concentrated in one place for too long. on/off switch fl...
- Page 7 Floor nozzle Ú manufacturer. Accessory adaptor The floor nozzle is used for the cleaning of large, washable walls and floor areas. The floor nozzle can be used with or without the 1 Push the jet nozzle adaptor as far as it cotton towel Û.
- Page 8 2 It can be used with various fittings, eg the 3 Turn anti-clockwise and pull to remove. angled nozzle and small and large brush • This nozzle is ideal for cleaning cushions, attachments, depending on the task. carpets and car seats. •...
-
Page 9: Cord Storage
from a distance of 20-25 cm. Continue at a into the tank. distance of 10-15 cm. 5 Fit the cap and tighten fully. 6 Using the handle, move the steam cleaner about to swill the solution around Cord storage the tank. 7 Leave for 30 minutes. - Page 10 Model number and Serial number on the 4 Where the appliance has been used for product, or write to Morphy Richards at the hire purposes or non domestic use. address shown. 5 Morphy Richards are not liable to carry...
- Page 11 guarantee is offered as an additional benefit and does not affect your statutory rights as a consumer. • This guarantee is valid in the UK and Ireland only.
- Page 12 Morphy Richards products are intended for household use only Morphy Richards has a policy of The After Sales Division, continuous improvement in product Morphy Richards Ltd, Mexborough, quality and design. The Company, South Yorkshire, England, S64 8AJ therefore, reserves the right to change...