Table of Contents
Advertisement
Using
IMPORTANT: Please remember that the
steam cleaner operates by emitting steam at
an increased temperature of 130˚C. Never
use it on objects or surfaces which cannot
resist this temperature, delicate materials,
dralon, plastic, natural fur etc. Where any
doubt exists check carefully on a part of the
material where minor marks will not matter.
Filling the boiler
Ensure the cleaner is unplugged from the
mains supply before filling or re-filling.
1 Unscrew the filler cap ‡ by turning anti-
clockwise D.
2 Fill the boiler with a maximum of 0.75
litres of water by using the jug and funnel
provided E. Warm water may be used
which will reduce the heat-up time. Do
not use any detergent. IMPORTANT: The
use of any other fluids can be dangerous
and can lead to damage of the heating
element.
3 Refit the filler cap and fully tighten by
turning clockwise.
The filler cap has a safety device which
prevents the filler cap being undone when
there is steam pressure in the tank. This is
shown by a red safety indicator which
pushes out when there is steam pressure
inside the tank and goes back in again when
it is safe to refill.
Re-filling the boiler
WARNING: Always switch off, unplug
from the mains supply and release all
steam before opening and removing the
filler cap.
1 Release the steam pressure by pressing
the steam trigger Á on the handle until
all the steam has been expelled F. Leave
the cleaner to cool down for a few
minutes.
2 Fill the boiler as previously.
• Use warm water to reduce the risk of
spitting.
Boil dry cut-out
If the cleaner has boiled dry, switch it off
for a few minutes to allow the safety cut-out
to reset.
D
E
F
G
5
Advertisement
Table of Contents
