Table of Contents
Advertisement
Switching on
1 Insert the plug into the power socket.
2 Switch the cleaner on by pressing the
on/off switch fl to 'on' G. The red
power indicator light · and the green
thermostat indicator light ‚ will
illuminate. It will take approximately five
minutes to reach the correct temperature.
3 When the correct temperature has been
reached the green thermostat indicator
light will go out. The steam cleaner is
now ready to use.
The green thermostat indicator light will
cycle on-and-off during operation to show
that the cleaner is maintaining the correct
temperature.
WARNING: To avoid injury, the
cleaner should be switched off during
breaks or pauses of work. For extra
safety apply the trigger safety lock.
If you leave the working area, please
switch the cleaner off and unplug.
Steam cleaning
1 Ensure the safety lock Ê is off. Push the
lock from the left side to lock the trigger
and push from the right to release the
lock H.
2 Press the steam trigger Á and steam will
be emitted from the nozzle. Direct the
steam at a cloth or into a bucket or sink
until the steam is emitted evenly.
WARNING: At the start hot water
may be ejected.
WARNING: Aim the steam safely.
3 Keep the steam trigger pressed and
direct the steam at the surface to be
cleaned, removing the dirt by moving the
steam jet backwards and forwards over
the area.
6
4 To stop the steam jet, release the steam
trigger.
IMPORTANT: Do not hold the steam jet
concentrated in one place for too long.
• To control the steam temperature and the
cleaning power move the handle closer to
or further away from the surface being
cleaned.
Accessories
WARNING: Unplug the cleaner and
allow to cool before fitting or changing
attachments as they become hot during
use.
Attach the desired accessory to the hose
handle Â. Extension tubes can be attached
to the handle for extra reach.
1 Push the extension tubes È onto the
handle connection nozzle as far as they
will go until you hear a click J.
• Some tasks may be easier with only one
tube fitted or none at all.
2 To connect the desired accessory directly
to the hose handle, slide the handle into
the accessory head or tube until it locks
in place K.
H
J
K
Advertisement
Table of Contents
