Advanced Operation - Morphy Richards IB27015 Operating Instructions Manual

Advanced operation

Turning the radio on and off
1 Press and release the POWER button to turn on. If the unit is
switched on for the first time, the unit will automatically select DAB
mode and an autotune will start.
2 The number on the top line will increment when stations are found
and the bottom line will change when multiplexes are found.
All stations that are found will be stored alphanumerically. When
the autotune has finished, the first station in the alphanumerical list will
start playing. This is only applicable for the first time the unit is
powered up. The stations are stored in memory when the radio is
turned back on, the previous station listened too will start playing.
It is safe to disconnect the power from the unit without losing the
settings stored.
If no stations are found, then try the following: -
• Ensure that the telescopic aerial is fully extended.
• Move the unit to a new location (see section 'Improving reception
on your DAB radio').
• Try fitting an external aerial (see section 'Improving reception on
your DAB radio').
Tuning (DAB)
To tune to another station, press the UP or DOWN button, the top line
will show the station name and the bottom line will show the type of
station. Each subsequent press of either the UP or DOWN button, the
station will step up or down according to the alphanumerical list.
• When a station is reached that you want to listen to, press and
release the SELECT button to tune to that station. A brief 'tuning to
station' may be seen. That station name will appear on the top line
and the bottom line will show information depending upon what the
info button is set to (see info button section).
• If the SELECT button is held down when selecting a station, then
the autoselect will be turned to off. When this happens, there is no
need to press select to tune to a station. When scrolling up or
down through the station list using the UP or DOWN buttons, the
radio will tune to that station after 2 seconds automatically when
the up or down button is released.
• To change back, press either the UP or DOWN button and press
and hold SELECT. The display will read 'autoselect on'.
• Press and hold SELECT button to enter the manual tuning mode for
DAB. The display will say manual tuning and the following will be
displayed (this is an example, your display will depend upon the
tuning block selected).
5