Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Morphy Richards IB27010
Summary of Contents for Morphy Richards IB27010
- Page 1 Touch screen radio 27010 OPERATING INSTRUCTIONS...
- Page 2 Illustration 8 9 10 11 Touch screen rod The touch screen rod is used for pressing the touch screen buttons. To store clip the rod onto the telescopic aerial as shown.
-
Page 3: Locations Of Control
Locations of control Volume control Tone switch Earphone socket DC socket (DC 6V ) for adaptor (supplied). Battery compartment - (underneath the unit). Preset station buttons 1-5 Dual time button - for time 1 and 2. Memory/time button - for setting time 1 and 2 and preset radio stations. Lock switch 10 Select button - for selecting programmed stations. -
Page 4: Electrical Requirements
Electrical requirements Check that the voltage on the rating plate of your AC/DC adaptor corresponds with your house electricity supply which must be A.C. (alternating current). Power supply Connecting AC/DC adaptor (supplied). As soon as you connect AC/DC adaptor the clock will start working at 12:00. -
Page 5: Setting The Clock Time
Setting the clock time The clock must be set with the unit switched off. Time 1 is to set the normal time and Time 2 can be set to view an additional world time. A single press of the Down/minute button or Up/hour button advances the •... -
Page 6: Radio Operation
Radio operation Note: The lock switch must be set to the unlock position. Switch the unit on by pressing the Power on/off button on the touch screen display. To obtain the maximum reception for SW and FM fully extend the telescopic aerial which is located at the rear of the unit and alter the direction for best results. -
Page 7: Selecting Preset Stations
Preset stations You can store a total of 40 memory stations (10 on each waveband). Tune to the required station as described for ‘Radio operation’. Press the Memory/time button (a), and ‘MEMO’ will flash for several seconds. Press the Preset stations buttons 1-5 or SLCT (select) button for locations 1-10. -
Page 8: Setting The Alarm Time
Last station memory function The frequency of the last station tuned to before switching off the unit will be stored in the memory. When the unit is switched on again, it will receive this station in the respective waveband. When you are changing the waveband, the last station tuned on each waveband will also be stored in memory. -
Page 9: Sleep Function
Snooze To silence the alarm temporarily press the Snooze button which is located on the front of the unit. The alarm will sound again in 9 minutes time. You can press the Snooze button as many times as desired. Sleep function Select the required station as described in ‘Radio Operation’. -
Page 10: Display Illumination
To cancel the timer change the timer time until the display reads ‘00’. Wait for 5 seconds the display will revert back to the time display. The buzzer will sound at the end of the set time. Press Timer button once to turn off the buzzer. -
Page 11: Warning Labels
Warning labels WARNING: To reduce the risk of electric shock, do not expose this appliance or adaptor to rain or moisture. ATTENTION: To reduce the risk of electric shock, do not remove the cover. There are no user serviceable parts inside the unit. Refer any servicing to qualified personnel. - Page 12 TWO YEARS from date of purchase. If your product proves to be defective within 28 days of purchase, your Morphy Richards dealer from whom the product was purchased will be pleased to replace it free of charge.