Motor Protection Filter; Exhaust Filter - Morphy Richards ESSENTIALS BAGLESS VACUUM CLEANER Manual

73206 rev2 11/6/08
K
L
U U K K H H e e l l p p l l i i n n e e 0 0 8 8 4 4 4 4 8 8 7 7 1 1 0 0 9 9 4 4 9 9
6 6
09:53 Page 6
Washing the pleated
filter
For total cleaning of the pleated
filter, it should be washed with
warm water with no detergents.
Allow filter to air dry.
IMPORTANT: The filter must be
completely dry before re-fitting.
FILTERS

Motor protection filter

This cleaner is fitted with a
motor protection filter.
IMPORTANT: NEVER USE THE
VACUUM CLEANER WITHOUT
THIS IN PLACE.
To clean the motor
protection filter
1 Remove the filter from the filter
grille K.
2 Rinse the filter in luke warm
water and dry the filter
completely.
3 Put the filter back into the filter
grille and reassemble.
R R e e p p l l a a c c e e m m e e n n t t P P a a r r t t s s 0 0 8 8 4 4 4 4 8 8 7 7 3 3 0 0 7 7 1 1 5 5

Exhaust filter

Remove the exhaust filter grille
by pulling the locking tab
towards you L. Take the filter
out of the cage and shake
vigorously over a dustbin. The
filter may also be washed in
warm water. Do not use
detergents. The filter must be
completely dry before re-fitting.
Allow filters to air dry naturally.
Replace the filter and filter grille.
IMPORTANT
• Always disconnect the cleaner
from the mains when checking
filters.
• All filters should be checked
regularly for signs of damage,
preferably after each cleaning
task. The filters must be
replaced immediately if they
become damaged.
• Always make sure all filters are
fitted before use. Failure to do
so may result in damage to your
product.
• If the sound of the cleaner
changes slightly, clean the filters
and check for blockages.
I I r r e e l l a a n n d d H H e e l l p p l l i i n n e e 1 1 8 8 0 0 0 0 4 4 0 0 9 9 1 1 1 1 9 9