INTRODUCTION Dear Consumer, Congratulations, you have just acquired a SounDigital product of the highest technology and quality, so we thank you for your trust. SounDigital products are made with raw materials of the highest quality standards, and the most modern processes, equipment and technology are used in their production.
Wear gloves, safety glasses firmly. Avoid fixing to metallic and all necessary PPE during parts of the vehicle, as this the installation of SounDigital procedure may cause ground amplifiers. looping (noise); THIS "WARNING" SIGN ALERTS THE USER OF IMPORTANT INFO. NOT FOLLOWING THESE INSTRUCTIONS MAY CAUSE INJURIES TO THE USER OR DAMAGE TO THE EQUIPMENT.
ASSEMBLING AND DISASSEMBLING THE PLASTIC COVER The plastic covers are used to finish and hid the amplifier ’s fixing screws. To disassembl and assembl them, follow the instructions below. DISASSEMBLING OF THE PLASTIC COVER 1. Carefully pull out the top of the plastic cover to release the upside latches, as shown in picture 1. 2.
PANELS DESCRIPTION Blue "POWER ON" LED indicator CH 1 Audio input – RCA connectors CH 2 CH 1 Audio input – High Level (To connect to the speaker output of the head unit) CH 2 Variable Gain control Crossover Switch Low Pass - Full - High Pass...
INSTALLATION SEQUENCE BEFORE PROCEEDING WITH THE INSTALLATION, UNPLUG THE NEGATIVE TERMINAL FROM ALL OF THE BATTERIES, TO AVOID FIRE, DAMAGE TO THE AMPLIFIER AND THE USER HIMSELF. Warning! Ø Mount the amplifier in such a way you have access to the connectors; Ø...
ELECTRICAL DIMENSIONING AND AUDIO INPUTS ELECTRICAL DIMENSIONING For proper operation of your SounDigital amplifier, you need the proper dimensioning of the electrical system and the cables used. The table below shows the minimum section of GND cables, +12VDC cables and speaker output cables according to the power generated by the amplifier.
GAIN SETTING GAIN SETTING Necessary equipament: Ø On the audio player, set the fader Ø Digital AC voltmeter; control to center position; Ø Media with sine wave test tone 60Hz Ø Set the crossover selector switch recorded at 0db; in "F"; Ø...
CROSSOVER SET UP "F" All the frequencies will be reproduced "LP" Frequencies below 80Hz will be reproduced "HP" Frequencies above 80Hz will be reproduced Change the switch to "F" position (Full Range) - All frequencies will be Ø reproduced as shown in the figure below; -3dB 10Hz 20kHz...
All RCA inputs must be connected for the amplifier to work properly. (PER CHANNEL) Minimum impedance Model Per channel Bridge 1200.2 EVO5 2Ω 1Ω 2Ω 1200.2 EVO5 4Ω 2Ω 4Ω 1 CHANNEL WIRING DIAGRAM (BRIDGE) In case of connections with more than one battery, see the "AUDIO...
BATTERY CONNECTION DIAGRAM When necessary the association of one or more battery banks to supply the necessary current to the amplifier, it is recommended to use batteries of the same brand, model, and if possible the same manufacturing lot so that the system has the maximum performance.
AMPLIFIER OPERATIONAL LEDS "POWER" LED indicator (blue) LED "POWER" Off ........Product off. LED "POWER" On ........Product on. *Merely illustrative image.
In the vast majority of cases, situations that at first glance appear to be a defect can be adjusted and resolved by yourself without the need to seek Authorized SounDigital Technical Assistance. If the problem persists after carrying out the corrective actions below, contact our nearest technical team.
The values presented are based on measurements performed in Updates of information made in this document will always be SounDigital's laboratories. All the equipment used in the assays, tests, published and made available for consumer consultation, free of measurements and gauging of the technical parameters of SounDigital charge, on the brand's websites.
Need help?
Do you have a question about the 1200.2 EVO5 and is the answer not in the manual?
Questions and answers