DNIPRO M ND-45 Safety And Operating Instructions Manual page 19

11. STORAGE AND
TRANSPORTATION
Store the power tool at a temperature
between -5 °C and +40 °C and relative
humidity of no more than 90%, in a dry
place protected from direct sunlight and
out of the reach of children. The presence
of acid vapors, alkalis and other aggres-
sive impurities in the air is not allowed.
It is recommended that you transport and
store the power tool, the original safe-
ty and operating instructions, and acces-
sories in the original packaging or other
packaging that prevents damage.
During loading and unloading operations
and transportation, the power tool must
not be exposed to shocks and precipita-
13. POSSIBLE MALFUNCTIONS AND METHODS OF THEIR ELIMINATION
Description of the
fault
The power tool
does not turn on
The chuck speed
is not adjustable,
the drilling/drilling
mode is not acti-
vated
Accessory jams in
the chuck
EU-NDHDTD0823001-0823002
Possible cause
Circuit breaker malfunction
The power cord and/or
plug are damaged
There is no voltage at the
plug of the power tool
power cord
Inconsistency of power
grid parameters
Malfunction of power tool
controls
Incorrectly inserted acces-
sories into the chuck
Cartridge malfunction
tion. The placement and fastening of the
power tool in vehicles must ensure a sta-
ble position and the absence of the possi-
bility of movement during transportation.
12. UTILIZATION
Do not dispose of power tools with
household waste!
Power tools that have been decommis-
sioned must be stored and disposed of
separately in accordance with environ-
mental legislation.
Disconnect the battery pack before dis-
posing of it. Dispose of the battery pack
separately from the power tool.
Elimination
Contact the manufacturer (DNIPRO
M LLC), the DNIPRO-M service cen-
tre or the seller of the product.
The power cord and/or plug must
be replaced. Contact the manufac-
turer (DNIPRO M LLC), the
DNIPRO-M service centre or the
seller of the product.
Check and ensure that there is
voltage at the plug of the power
tool's power cord
Make sure that the power supply
has a voltage of 230 V ± 10% and a
current frequency of 50 Hz. If not,
use a voltage regulator.
Contact the manufacturer
(DNIPRO M LLC), the DNIPRO-M
service centre or the seller of the
product.
Open the chuck cams and pull out
the accessory. Insert the accessory
into the chuck without tilting it
Contact the manufacturer
(DNIPRO M LLC), the DNIPRO-M
service centre or the seller of the
product.
en
19