Welcome to Electrolux! Thank you for choosing our appliance. Get usage advice, brochures, trouble shooter, service and repair information: www.electrolux.com/support Subject to change without notice. CONTENTS 1. SAFETY INFORMATION................2 2. SAFETY INSTRUCTIONS................4 3. PRODUCT DESCRIPTION................6 4. TECHNICAL DATA..................7 5.
the use of the appliance in a safe way and understand the hazards involved. • Children between 3 and 8 years of age and persons with very extensive and complex disabilities shall be kept away from the appliance unless continuously supervised. •...
• The ventilation opening in the base must not be covered by a carpet, mat, or any floor covering. • The appliance must be connected to the water mains using the new supplied hose sets, or other new hose sets supplied by the Authorised Service Centre.
2.4 Use • Always use a correctly installed shockproof socket. • Make sure that the parameters on the WARNING! rating plate are compatible with the Risk of injury, electric shock, fire, burns electrical ratings of the mains power or damage to the appliance. supply.
vibration, humidity, or are intended to • Disconnect the appliance from the mains signal information about the operational electrical and water supplies. status of the appliance. They are not • Cut off the mains electrical cable close to intended to be used in other applications the appliance and dispose of it.
Drain hose Hose support Mains cable Rating plate Transit bolts Information for register product. The rating plate reports the model name The info label reports the model name (A), (A) , product number (B), electrical ratings (C) product number (B ) and serial number (C). and serial number (D).
5.1 Unpacking and positioning Adjust the appliance correctly to prevent vibration, noise and movement of the appliance when it operates. WARNING! Do not put cardboard, wood or equivalent materials below the appliance feet to adjust the level. Make sure that carpets do not stop the air circulation below the appliance. Make sure that the appliance does not touch the wall or other units.
5.2 The inlet hose Accessories delivered with the appliance may 0.3-10 bar vary depending on the model. 1/2” 3/4” 3/4” 3/4” Make sure there is no damage to hoses and there are no leaks from the couplings. Do not use an extension hose if the inlet hose is too short.
Check that your domestic electrical The power supply cable must be easily installation can take the maximum load accessible after installing the appliance. required, also taking into account any other For any electrical work required to install this appliances in use. appliance, contact our Authorised Service Connect the appliance to an earthed Centre.
Page 11
6.2 Display Lid locked indicator. Delay start indicator. The digital indicator can show: • Programme duration (e. g. • Delay time (e. g. • Cycle end ( • Warning code (e.g. • Indication of total operating hours of the appliance. Refer to the "Operat‐ ing hours counter"...
7. DIAL AND BUTTONS 7.1 Introduction delicate fabrics. The rinse phase uses more water for some washing programmes • Rinse Hold . The related indicator The options/functions are not available comes on. with all washing programmes. Check the The final spin is not performed. The water compatibility between options/functions of the last rinse is not drained out to and washing programmes in the...
This option is recommended for heavily Pause button, the appliance begins the soiled laundry, especially if containing countdown and the lid is locked. sand, dust, mud and other solid particles. 7.9 Time Manager With this option you can reduce the These options can increase the programme duration.
8. PROGRAMMES 8.1 Programme Chart Programme Reference Maxi‐ Programme description Default tempera‐ spin speed (Type of load and level of soiling) ture Spin speed load Temperature range range [rpm ] Eco 40-60 1200 rpm 7 kg White cotton and fast-coloured cotton. Normally soiled (1200- 400) items.
Page 15
Programme Reference Maxi‐ Programme description Default tempera‐ spin speed (Type of load and level of soiling) ture Spin speed load Temperature range range [rpm ] 1200 rpm 1 kg Machine washable wool, hand washable wool and other Wool (1200- 400) fabrics with «hand washing»...
Programme Reference Maxi‐ Programme description Default tempera‐ spin speed (Type of load and level of soiling) ture Spin speed load Temperature range range [rpm ] 800 rpm 2 kg Special programme for Denim clothing with delicate Denim (1200 - 400) washing phase to minimize colour fading and marks.
8.2 Woolmark Wool Care - Blue The wool wash cycle of this machine has been approved by The Woolmark Company for the washing of wool gar‐ ments labelled as «hand wash» provided that the prod‐ ucts are washed according to the instructions on the gar‐ ment label and those issued by the manufacturer of this washing machine.
3. Press and hold the buttons for some seconds (within 10 seconds after If the procedure does not work (due to the switching on. After these 10 seconds, timeout, wrong programme dial position the key combination activates and or wrong keys combination), switch the deactivates the acoustic signals).
Page 20
4. Shake the items before you put them in 2. Put the detergent and the fabric conditioner the appliance. into the proper compartments. Make sure not to put too much laundry in the drum. 5. Close the drum and the lid. Always obey the instructions that you find on the packaging of the detergent CAUTION!
11.4 Liquid or powder detergent CLICK CLICK 11.6 Starting a programme • Position A for powder detergent (factory setting). Touch the Start/Pause button to start the • Position B for liquid detergent. programme. It is not possible to start the programme when the indicator of the button is off and doesn't flash (e.g.
Cancelling the delay start after the countdown has started The SensiCare System is not available To cancel the delay start: with all programmes such as :Wool, Rinse, Spin and programmes with short 1. Touch the Start/Pause button to cycles. pause the appliance. The related indicator flashes.
11.11 Opening the lid - Adding 11.13 Draining water out after end garments of cycle If you have chosen a programme or an option that does not empty out the water of the last rinse, the programme is completed, but: If the temperature and level of the water in the drum are too high and/or the drum •...
If you set a programme or an option that ends with water in the drum, the Stand- by function doesn't deactivate the appliance to remind you to drain the water. 12. HINTS AND TIPS -manually redistribute the load so that the WARNING! items are spaced evenly around the tub;...
powder detergents containing bleach • Normally soiled laundry may be washed for whites and laundry sanitization, without prewash in order to save – liquid detergents, preferably for low detergent, water and time (the temperature wash programmes (60 °C environment is protected too!). max) for all types of fabric, or special •...
13.4 Descaling Indicative periodic cleaning schedule: Descaling Twice a year Maintenance wash Once a month If the water hardness in your area is high Clean lid seal Every two months or moderate, we recommend that you use a water descaling product for Clean drum Every two months washing machines.
13.7 Lid seal 1. Remove all laundry from the drum. 2. Run a Cottons programme with the Regularly examine the seal and remove all highest temperature. objects from the inner part. Clean it when 3. Add a small quantity of powder detergent needed, using ammonia cream cleanser into the empty drum, in order to rinse out agent without scratching the seal surface.
Always keep a rag nearby to dry up any WARNING! water spillages when removing the filter. • Disconnect the mains plug from the mains socket. • Do not clean the pump if the water in the appliance is hot. Wait until the water cools down .
14. TROUBLESHOOTING WARNING! Refer to Safety chapters. 14.1 Alarm Codes and Possible failures The appliance does not start or it stops during operation. First try to find a solution to the problem (refer to the tables). WARNING! Deactivate the appliance before carrying out any check. With some problems, the display shows an alarm code and the Start/ Pause button may flash continuously:...
Page 30
If the display shows other alarm codes, deactivate and activate the appliance. If the problem continues, contact the Authorised Service Centre. In case of different problem with the washing machine check the table below for possible solutions. Problem Possible solution •...
Problem Possible solution Too much foam in the drum • Reduce the quantity of detergent. during the washing cycle. After the washing cycle, • Make sure that the flap is in the correct position. there are some detergent • Make sure you have used the detergent dispenser according the indications residues in the dispenser given in this user manual.
Page 32
15.3 According to Commission Regulation Eu 2019/2023 Eco 40-60 pro‐ rpm 1) Litres hh:mm °C gramme Full load 1.160 50.0 3:25 53.00 1151 Half load 0.630 39.0 2:40 53.00 1151 Quarter load 0.400 32.0 2:40 55.00 1151 Maximum spin speed. Power consumption in different modes Off (W) Stand-by (W)
16. QUICK GUIDE 16.1 Daily use Connect the mains plug to the mains socket. 2. Set the desired options (1) by means of the corresponding touch buttons. To start Open the water tap. the programme, touch the Start/Pause Load the laundry. (2) button.
Потрошња воде у Потрошња енергије у литрима по циклусу, на кWh по циклусу, на темељу програма „еко темељу програма „еко 40/60” при комбинацији 40/60” при комбинацији потпуног и делимичног потпуног и делимичног 0.783 пуњења. Стварна пуњења. Стварна потрошња воде зависи потрошња...
Page 36
the household waste. Return the product to your local recycling facility or contact your municipal office. ENGLISH...
Need help?
Do you have a question about the EW6TN4272 and is the answer not in the manual?
Questions and answers