Roller Sun Blinds - BMW SERIE 5 SPORT WAGON 2004 Owner's Manual

The equipment can be used as of ignition
key position 2.
If the device cannot be used even
after repeated programming, check
whether the original hand-held transmitter
is equipped with an alternating-code sys-
tem. Here, either read the instructions for
the original hand-held transmitter or hold
down the programmed memory button 1 of
the integrated universal remote control. If
the indicator lamp 2 on the integrated uni-
versal remote control flashes rapidly for a
short time then lights up for approx. 2 sec-
onds, this indicates that the original hand-
held transmitter uses an alternating-code
system. In the case of an alternating-code
system, program the memory buttons 1 as
described at Alternating-code hand-held
transmitters.<
Alternating-code hand-held
transmitters
To program the integrated universal remote
control, consult the operating instructions
for the equipment to be set. You will find
information there on the possibilities for
synchronization.
When programming hand-held transmitters
that employ an alternating code, please
observe the following supplementary
instructions:
Programming will be easier with the
aid of a second
1. Park your vehicle within the range of the
remote-controlled device
2. Program the integrated universal
remote control as described above at
Fixed-code hand-held transmitters
3. Locate the button at the receiver of the
equipment to be set, e.g. on the drive
4. Press the button on the receiver of the
device you want to set up. After step 4,
you have approx. 30 seconds for step 5
5. Press the programmed memory
button 1 of the integrated universal
remote control three times.
person.<
Online Edition for Part No. 01 41 0 157 647 - © 07/03 BMW AG
The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.
If you have any additional questions,
please contact your BMW
Clearing the memory buttons
Press both outer buttons 1 of the inte-
grated universal remote control for approx.
20 seconds until the indicator lamp 2
flashes. All memory buttons will be cleared.
The memory of individual memory
buttons 1 cannot be cleared.

Roller sun blinds*

Roller sun blind for rear window
To actuate as of ignition key position 1,
briefly press the button in the driver's door.
Roller sun blinds for rear side
windows
Pull the roller sun blind at the loop and
hook up to the bracket.
center.<
97