Maintenance For Cutting Blades - MAMMOTION LUBA 2 AWD Series User Manual

Hide thumbs Also See for LUBA 2 AWD Series:

Table of Contents

5.2

Maintenance for Cutting Blades

WARNING

Always wear protective gloves when inspecting, cleaning, or replacing the cutting blade.

2. DO NOT use an electrical screwdriver to tighten or loosen the cutting disk. Always use the correct

screws and original blades approved by Mammotion.

3. Replace all cutting blades and their screws simultaneously to ensure a safe and effective cutting

system.

4. DO NOT reuse the screws, which may cause serious injury.

Replace the cutting blades every 3 months or after 150 hours of mowing. For thicker grass, you may need

to replace the blades more frequently.

How to replace a cutting blade

Turn off the robot.

2. Place Luba on a soft, clean surface, ensuring it is in an upside-down position.

3. Remove the old cutting blades with a Phillips screwdriver.

4. Install the new cutting blades using the included washers (B) and screws (A). Ensure that the blades

can rotate freely and are securely installed.

- 82 -

Table of Contents

Do you have a question about the LUBA 2 AWD Series and is the answer not in the manual?