BMW F 650 GS Rider's Manual page 64

engine, or use jump leads and a
5
donor battery to start.
The engine starts.
60
If the engine refuses to start,
consult the troubleshooting
chart in the section entitled
"Technical data". (
Pre-ride check
The instrument panel runs a test
z
of the instruments and the telltale
and warning lights when the ig-
nition is switched on: this is the
Pre-Ride-Check The test is abor-
ted if you start the engine before
it completes.
Phase 1
The rev. counter and speedo-
meter needles both swing to
the limit values on their scales.
At the same time, all the warn-
ing lights and telltale lights are
switched on in succession.
Phase 2
The 'General' warning light
changes from yellow to red.
Phase 3
The rev. counter and speedo-
meter needles both swing back
124)
to rest. At the same time, all the
warning lights and telltale lights
switched on in the initial phase
are switched off in reverse se-
quence.
If a needle did not move or if a
warning light or telltale light did
not show:
Some malfunctions cannot
be indicated if one of the
warning lights fails to show.
Make sure that all the warning
and telltale lights come on in the
pre-ride check.
Have the fault rectified as
quickly as possible by a
specialist workshop, preferably
an authorised BMW Motorrad
dealer.
ABS self-diagnosis
with BMW Motorrad ABS
BMW Motorrad ABS performs
self-diagnosis to ensure its op-
erability. Self-diagnosis is per-
formed automatically when you
switch on the ignition. The mo-
torcycle has to move forward a
few metres for the wheel sensors
to be tested.
Phase 1
Test of the diagnosis-compat-
ible system components with
the motorcycle at a standstill.
ABS warning light flashes.
Phase 2
Test of the wheel sensors as
the motorcycle pulls away from
rest.
OE