Draper DMM8 Original Instructions Manual
Draper DMM8 Original Instructions Manual

Draper DMM8 Original Instructions Manual

Pocket digital multimeter

Advertisement

Quick Links

EN
Original Instructions
Version 2: January 2025
POCKET DIGITAL
MULTIMETER
68476

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DMM8 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Draper DMM8

  • Page 1 Original Instructions Version 2: January 2025 POCKET DIGITAL MULTIMETER 68476...
  • Page 2: Product Introduction

    Read this manual in full before attempting to assemble, Any other application beyond the conditions established operate or maintain the product, and retain it for later use. for use will be considered misuse. Draper Tools accepts 1.2 Specification Stock No. 68476 Part No.
  • Page 3: Health And Safety Information

    − DO NOT use this product if the device, case or   probe leads are damaged in any way or if there is evidence of battery leakage. Contact Draper Tools WARNING! ALWAYS ensure that the operator is for replacement options if the leads become not in contact with the ground while taking damaged.
  • Page 4: Product Overview

    Please examine it for any signs of damage that may have contact the Draper Helpline; contact details can be found occurred during shipment. If any part is damaged or at the back of this manual.
  • Page 5: Installing/Replacing The Battery

    5. Operating Instructions Important: Before operating this product, read and understand all the safety instructions listed in this manual. 5.1 Installing/Replacing the Battery - Fig. 1 Important: Use ONLY 9V PP3 batteries. WARNING! Remove the test leads from the circuit under test and turn the function dial to (F1) the ‘OFF’...
  • Page 6: Warranty

    6. Measurements Mode Dial Position Action 1. Connect the positive (+) red probe (8) to the ‘V/mA’ terminal (4) for measurements between 200mA and 5A and to the 5A terminal (6) for 5A. 2. Turn the function selector dial (2) to the ‘current’ position. DC Current Mode Open the circuit to be measured and connect the test leads in series with the load to be measured.
  • Page 7: Maintenance And Storage

    8. Product Care and Disposal Important: Disconnect the probes from the terminals • If the test leads need replacing, the replacement leads and any other source of voltage before performing any must be rated at least 600V/5A. maintenance on this product. DO NOT attempt to repair • Store the device in a cool, clean and dry environment, or service the meter unless qualified to do so.
  • Page 8: Contact Details

    Product Helpline: +44 (0) 23 8049 4344 Telephone Sales Desk: +44 (0) 23 8049 4333 General Enquiries: +44 (0) 23 8026 6355 Please contact the Draper Tools Product Helpline for repair and servicing enquiries. © Published by Draper Tools Limited © Published by Draper Tools Limited...

This manual is also suitable for:

68476

Table of Contents