Download Print this page

Work Preparation; Removing And Inserting The Control Panel; Mains Operation - Kummert proTab Instruction Manual

Advertisement

Available languages

Available languages

WORK PREPARATION

Removing and inserting the control panel

The control panel can be operated independently of the base for all operations that do not
require a connection to the reel or the cable drum. For this purpose, the control panel is
removed from the holder and then reinserted.
Hold the control panel on both sides
with both hands. Pull the purple latches
on the back with your fingers outwards.
Lift the control panel off. Slide the
latches back slowly.
To insert it back, hold the control panel
on both sides with both hands. Pull the
purple latches on the back with your
fingers outwards. Insert the control
panel and make sure that it snaps
into the corresponding slots. Slide the
latches back slowly. Check that the
control panel is securely attached before
releasing it.

Mains operation

If the proTab is connected to Profi NG and this to a suitable power source, proTab is supplied
with power by Profi NG.
Connect the power plug of the optionally available charging adapter to a suitable power
source.
NOTE
Risk of property damage!
Over-voltage can lead to property damage or even total failure. Interruptions to the
power supply disturb the operation of the device and can lead to malfunctions and
data loss.
Ensure that the power supply is uninterrupted.
Ensure that the power source has over-voltage protection.
Ensure that the values listed in the technical data for the power supply are
complied with.
EN
25
25

Advertisement

Chapters

loading
Need help?

Need help?

Do you have a question about the proTab and is the answer not in the manual?

Subscribe to Our Youtube Channel