Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Kummert CamFlex 9900
Summary of Contents for Kummert CamFlex 9900
- Page 1 CamFlex ® Art.-No. 9900 Instruction Manual...
-
Page 2: Table Of Contents
Contents 1 General Information 1.1 About the Manual ....................3 1.2 Manufacturer .....................3 1.3 Explanation of Symbols Used ................3 1.3.1 Safety Instructions ..................3 1.3.2 Tips and Recommendations ..............4 1.4 Limitation of Liability ..................4 1.5 Copyright ......................4 1.6 Warranty Conditions ..................4 2 Safety 2.1 Proper Use ......................4 2.2 Basic Risks ......................5 2.3 Behaviour in the Event of Danger and Accidents ..........6... -
Page 3: General Information
Illustrations in this manual are intended to better represent the facts explained and may differ from the actual design of the device. 1.2 Manufacturer Address: Contact: Kummert GmbH Phone: +49 (0) 9382 - 9727 - 0 Albert-Einstein-Str. 8 Fax: +49 (0) 9382 - 9727 - 900 D - 97447 Gerolzhofen Email: info@kummert.de... -
Page 4: Tips And Recommendations
Any improper use is prohibited without the manufacturer’s written certifi cate of release. 1.6 Warranty Conditions The warranty conditions are included in the manufacturer’s General Terms and Conditions, which you can fi nd under www.kummert.de 2 Safety 2.1 Proper Use The camera CamFlex is solely intended to be used for the inspection of cleaned private ®... -
Page 5: Basic Risks
2.2 Basic Risks The following chapter lists residual risks which remain, even when the device is used in a proper manner. To reduce the risk of personal injuries and property damage and avoid dangerous situa- tions, the safety instructions listed below as well as the safety instructions listed in the sections to come are to be observed strictly! Warning! Risk of blinding by LEDs! -
Page 6: Behaviour In The Event Of Danger And Accidents
Warning! Explosion hazard! The device is not explosion-proof. Therefore: - Never operate the device in an explosive atmosphere. In this context, also make sure that the pipes to be inspected do not contain or leak explosive gases/liquids. Warning! Electrical hazard! Electric current can cause severe injuries or death. -
Page 7: Personnel Requirements
• The owner must precisely direct and defi ne the responsibilities in respect of installing, operating, trouble-shooting and cleaning the device. • The owner is to ensure that all individuals handling the device have read and understood this manual. Furthermore, the owner must periodically train all personnel and inform them about the dangers. -
Page 8: Spare Parts
Description of personal protective equipment: Protective Gloves Protective gloves protect hands against friction, abrasions, punctures or deeper injuries, as well as contact with hot surfaces. 2.7 Spare Parts Warning! Risk of injury due to using incorrect spare parts! The use of incorrect or faulty spare parts may pose a risk to the personnel, as well as cause damage, malfunctions or breakdown. -
Page 9: Specifi Cations Camflex
3.2 Specifi cations CamFlex ® Weight: 1050 g Diameter: 72 mm Length: 30 cm Camera: ¼“ Color-CCD; 0.5 Lux; 350 lines Lens: 2.4 mm Focus: controlled by motor Range of use: DN100 to DN200 Bending range: 90° in all directions Depth of fi... -
Page 10: Brief Description Camflex
The adjustable freewheel brake prevents unwanted coasting of the push rod during an inspection. Furthermore, a tubular attached to one side of the reel houses the mounted camera. All cameras and push rods in the Kummert CamMobile line are interchangeable. Howe- ®... -
Page 11: Transport, Packaging And Storage
5 Transport, Packaging and Storage 5.1 Safety Instructions for Transport NOTE Property damage due to improper transport! Improper transport may damage the camera, reel and push rod. - Always transport the push rod reeled in. - Always transport the camera in the carrying case. - When transporting the reel in a vehicle, secure it against falling over. -
Page 12: Storage
5.4 Storage Always store the CamFlex and push rod/reel under the following conditions: ® • Do not store outdoors. • Always store the camera in the carrying case or, at least, with the protective cap mounted to the connector. • Store in a dry and dust-free place. •... - Page 13 1. Turn the wing nut (fi g. 1) counterclockwise to reduce the braking force of the freewheel brake. fi g. 1 2. Turn the knob for the reel lock (fi g. 2) while holding on to the push rod or reel. The lock pin releases the reel.
-
Page 14: Initial Operation
7 Initial Operation NOTE Property damage due to faulty initial operation and use! Faulty initial operation and use of the camera may cause property damage or breakdown. Therefore: - Never push or pull the rod across sharp edges. - The rod may only be used to operate the camera. It must not be used as a towing rope. -
Page 15: Calibrating The Camera
7.2.3 Calibrating the Camera During an inspection, the CamMobile Profi 3 automatically calibrates the CamFlex ® ® several times if the need arises. This happens before the fi rst lateral or bend is being measured, as well as every time before measurements are taken and the camera’s temperature has changed by 5°... -
Page 16: Cleaning And Maintenance
8 Cleaning and Maintenance NOTE Property damage due to incorrect cleaning! Incorrect cleaning may cause damage or breakdown. Therefore: - Clean the camera and reel only in a de-energized state. - Never use a high-pressure washer or similar means for cleaning. - Do not use abrasive, corrosive or other aggressive detergents. -
Page 17: Disposal
poor illumination clean the lighting dome camera bent push the aligning-button on the CamMobile ® Profi 3 twice (see chapter “7.2.4 Pulling Back the Camera”) push rod/reel reel is blocked check if object extents into the basket and remove it, if needed; release reel lock pin push rod unreels with diffi... -
Page 18: Accessories
11 Accessories • Protective cap for the HR-plug of the rod and locating transmitter (camera side) Art.-No. 5916 • Protective cap for the HR-plug of the cameras, centering trolley with additional lighting and locating transmitter (rod side) Art.-No. 5917 • Protective cap for the 7-pin plug of the reel Art.-No. - Page 19 Notes:...
- Page 20 Manufacturer: Distributor: Kummert GmbH Albert-Einstein-Straße 8 D - 97447 Gerolzhofen Phone.: +49 (0) 9382 97 27 - 0 Fax: +49 (0) 9382 97 27 - 900 info@kummert.de www.kummert.de...
Need help?
Do you have a question about the CamFlex 9900 and is the answer not in the manual?
Questions and answers