Display - Dell Inspiron 9300 Owner's Manual

coin-cell battery
battery cable connector
5 Install the replacement battery:
Insert the battery at a 30-degree angle under the release latch with the positive side up,
a
and then push the battery into place.
Connect the battery cable to the connector on the system board.
b
6 Replace the keyboard.
7 Replace the hinge cover.

Display

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by
periodically touching an unpainted metal surface (such as a connector on the back of the computer).
NOTICE:
To avoid damaging the system board, you must remove the main battery before you begin
working inside the computer.
1 Follow the procedures in "Before You Begin" on page 81.
2 Loosen the two captive screws and remove the Mini PCI card cover.
3 Disconnect the antennae cables from the Mini PCI card.
release latch
Adding and Replacing Parts
95