Dell Inspiron 530b Owner's Manual page 141

1
2
3
1 hard drive
4 system board connector
NOTE:
The location of connectors on the system board may vary depending on
your computer.See "Inside View of Your Computer" on page 109.
5 Remove the four screws securing the hard drive.
NOTICE:
Ensure that you do not scratch the screw holes with the screw driver as
the hard disk circuit board assembly is exposed here.
6 Slide the drive out away from the front of the computer.
7 If removing this drive changes the drive configuration, then be sure to
reflect these changes in system setup. When you restart your computer,
enter system setup (see "System Setup" on page 187), then go to the
"Drives" section of the System Setup and under Drive 0 through 3, set the
Drive to the correct configuration.
2 power cable
5 screws (4)
Removing and Installing Parts
5
4
3 serial ATA data cable
141