6 If you are removing the card permanently, install a filler bracket in the
empty card-slot opening.
NOTE:
Installing filler brackets over empty card-slot openings is necessary to
maintain FCC certification of the computer. The brackets also keep dust and
dirt out of your computer.
7 Replace the card retention bracket, ensuring that:
•
The guide clamp is aligned with the guide notch.
•
The tops of all cards and filler brackets are flush with the alignment bar.
•
The notch in the top of the card or filler bracket fits around the
alignment guide.
8 Fix the card retention bracket by replacing and tightening the screw.
NOTICE:
To connect a network cable, first plug the cable into the network device
and then plug it into the computer.
9 Replace the computer cover, reconnect the computer and devices to
electrical outlets, and then turn them on.
10 Remove the card's driver from the operating system.
11 If you removed a sound card:
Enter system setup (see "System Setup" on page 187), go to Onboard
a
Devices and select Integrated Audio, and then change the setting to On.
Connect external audio devices to the audio connectors on the back
b
panel of the computer. See "Back View of the Computer" on page 19.
12 If you removed an add-in network connector:
Enter system setup (see "System Setup" on page 187), go to Onboard
a
Devices and select Integrated NIC, and then change the setting to On.
Connect the network cable to the integrated connector on the back
b
panel of the computer. See "Back View of the Computer" on page 19
and "Back Panel Connectors" on page 22.
Removing and Installing Parts
135