Trouble Shooting - Minolta DYNAX 303 SI Instruction Manual

TROUBLE SHOOTING

Contact your nearest Minolta Service Facility if the following
information does not cover the problem which you are experiencing
or the condition continues.
PROBLEM
No display appears when
the camera is switched on.
Autofocus does not work
when shutter-release button
is pressed partway down.
Shutter cannot be released.
Flash fires when the
shutter-release button is
pressed partway down.
Flash picture is too dark.
Lower part of flash picture
is dark.
Err appears in the data
panel.
56
CAUSE
Batteries are loaded incorrectly.
Batteries are exhausted.
Situation is unsuitable for autofocus.
Camera is set to manual focus
mode.
Subject is too close.
Focus cannot be confirmed.
Camera is attached to a microscope
or telescope.
The AF illuminator is on.
Subject is beyond flash range.
Lens hood attached.
Camera Malfuction.
SOLUTION
Remove and reinstall the batteries.
If the camera battery is exhausted, install a new battery.
Use focus hold or manual focus.
Press the focus mode button to return the camera to
autofocus mode.
Check the minimum focus distance for your lens.
Use focus hold or manual focus.
Contact a Minolta service facility for information.
This is a normal camera operation.
(The AF illuminator can also be cancelled.)
Make sure the subject is within the flash range.
Remove lens hood.
Remove and reinstall the batteries. If normal camera
operation does not resume or the camera malfunctions
repeatedly, contact an authorized Minolta Service
Facility.
PAGE
12
12
22/45
45
-
22/45
-
46
23
27
12
57