Bathology Spectrum 511 Installation And Operation Manual

Sauna / bath color bathing experience

Advertisement

Quick Links

S p e c t r u m 511
S a u n a / B a t h
C o l o r B a t h i n g E x p e r i e n c e
Installation and Operation Manual
REV - 2.0-02/2025

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Spectrum 511 and is the answer not in the manual?

Questions and answers

Summary of Contents for Bathology Spectrum 511

  • Page 1 S p e c t r u m 511 S a u n a / B a t h C o l o r B a t h i n g E x p e r i e n c e Installation and Operation Manual REV - 2.0-02/2025...
  • Page 2: Important Safety Information

    IMPORTANT SAFETY INFORMATION PLEASE READ THIS MANUAL IN ITS ENTIRETY PRIOR TO INSTALLATION! IMPORTANT • Qualified Personnel Only: Installation of this system must be performed by a certified electrician, following all national electric code and local building code requirements. • Equipment Protection: The driver, power supply, and control unit must be installed in a dry location shield- ed from moisture, rain, and inclement weather.
  • Page 3: Package Contents

    PACKAGE CONTENTS Table below outlines the specific components included with different quantities of lights purchased. DMX Driver / Receiver RGB Control Output Box Power Supply AC Power Cable 25FT CAT 6 Cable 50FT DC Power Cable 1FT CAT 6 Cable LED Light LED Light Mounting Template 4-Port DC Splitter...
  • Page 4: Specifications

    SPECIFICATIONS DMX Driver LED Light Operating Voltage: 24V DC Operating Voltage: 24V DC Power Consumption: 4.2 - 12.6 watts per channel Power Consumption: 3 Watts Output Voltage: 12-36V DC LED Type: Output Current: 350mA Constant Current Lumens: Connections: Power In - DC Female Barrel Trim Finish: Stainless Steel DMX In/Out - RJ45 Cat6...
  • Page 5: Connection Diagram

    CONNECTION DIAGRAM 1 - 6 Lights Setup 120VAC POWER SUPPLY Not Used Splitter 50’ DC Cable Link to Second Driver (used for 8-12 lights) 1’ 25’ Cat6 Cable Cat6 Cable 25’ Cat6 Cable Control Installed Exterior Sauna Room Terminator (see pages 10-12 for use) Figure #1...
  • Page 6 CONNECTION DIAGRAM 8 - 12 Lights Setup Not Used POWER SUPPLY Splitter 1’ Cat6 Cable Link to Third Driver 25’ 25’ (used for 14-18 lights) Cat6 Cable Cat6 Cable 25’ Cat6 Cable Control Installed Exterior Sauna Room 50’ DC Cable...
  • Page 7: Installation

    INSTALLATION STEP 1 - DMX Driver Installation 1. DMX Driver Mounting: Mount the DMX driver in a dry and accessible location. Alternatively, install it inside a waterproof elec- trical enclosure for added protection. 2. Output Box Placement: Mount the Output box adjacent to the DMX driver (refer to Figure 1 for reference). 3.
  • Page 8: Step 3 - Control Unit Installation

    INSTALLATION STEP 3 - Control Unit Installation Figure #4 1. Control Unit Connection: • At the designated control location, locate the 25ft CAT6 cable routed from the DMX driver. Connect this cable to the RJ45 pigtail on the control. • Locate the 50ft DC power cable and connect it to the DC pigtail on the control.
  • Page 9 OUTPUT BOX SETTINGS Note: Input A will handle up to 6 lights. If using 7-12 lights then both inputs A and B will be used. 2 Lights Terminator DIP Switch A OUTPUT DIP Switch Terminator Lights (A/B) position 1 2 3 4 5 6 7 8 9 (A/B) 2,3,4 1 2 3 4 5 6 7 8 9 ON: 1,2,3,4...
  • Page 10 OUTPUT BOX SETTINGS Note: Input A will handle up to 6 lights. If using 7-12 lights then both inputs A and B will be used. 6 Lights DIP Switch 5-6 Lights OUTPUT DIP Switch Terminator Lights (A/B) position 1 2 3 4 5 6 7 8 9 (A/B) 2,3,4 (A/B) 3,4 1 2 3 4 5 6 7 8 9...
  • Page 11 OUTPUT BOX SETTINGS Note: Input A will handle up to 6 lights. If using 7-12 lights then both inputs A and B will be used. 10 Lights DIP Switch A OUTPUT DIP Switch Terminator Lights (A/B) position 1 2 3 4 5 6 7 8 9 (A/B) 2,3,4 1 2 3 4 5 6 7 8 9 (A/B) 3,4...
  • Page 12: Troubleshooting

    TROUBLESHOOTING No Power • Verify Power Source: Ensure the electrical outlet supplying power to the system is functional and has the appropriate voltage. • Check DC Splitter Connections: Inspect the connections on the DC splitter for any loose or disconnected wires. Secure all con- nections firmly.
  • Page 13: Replacement Parts

    REPLACEMENT PARTS Not Shown SPECTRUM-68-TEMP Mounting Template BP031132 AC Power Cord BP031137 90W Power Supply POWER SUPPLY BP031138 4 Port DC Splitter BP031122 Driver Only BP031143 (no cables) DC Pigtail Cable BP031134 50’ DC Power Cable BP031141 RJ45 Pigtail Cable BP031141 RJ45 Pigtail Cable...
  • Page 14 © 2025 Bathing Brands, Inc. REV - 2.0-02/2025...

Table of Contents