Belkin F5D8633-4 User Manual page 21

Connecting and Configuring your Modem Router
Step 1 Hardware Connections – Follow the Quick Installation
Guide (QIG)
1.1
Brand-New Setup
Follow these steps if you are not replacing an existing modem.
If you are replacing an existing modem, skip to the next section,
"Replacing an Existing Modem or Modem Router", starting on
page 20.
modem router
A.
computer
B.
C.
Unpack your new Router from
the box and place it next to
your computer. Raise the
Router's antennas.
Retrieve the yellow RJ45 cable that
was included with your Router. First,
connect one end to any yellow port
labeled "to Wired Computers" on the
back of your Router. Then, connect
the other end to the networking port
on the back of your computer.
Retrieve the included gray RJ11
phone cord. Connect one end to
the gray port labeled "to ADSL"
on the back of your Router. Then
connect the other end to your ADSL
connection (either a wall jack or an
ADSL splitter).
Note: Some ADSL connections
require a microfilter. Your ADSL
provider can tell you if you need one.
Belkin includes a microfilter in regions
known to use them. You may or may
not have received one in your box.
19 19
1
2
3
4
5
6
7
8
9
10