Subscribe to Our Youtube Channel
Related Manuals for Ecler SAMI-603
Summary of Contents for Ecler SAMI-603
- Page 1 SAMI-603 ANALOGUE PREAMPLIFIERS & MIXERS Installation Mixers USER MANUAL 50-0453-0100 SAMI-603...
-
Page 2: Table Of Contents
TABLE OF CONTENTS 1. PRECAUTIONS..........................3 1.1 Important Notice ..........................3 1.2 Key Safety Directions ........................4 1.3 Cleaning Directions ........................4 2. WARRANTY & ENVIRONMENT ....................5 3. PACKAGE CONTENTS ........................5 4. DESCRIPTION & FEATURES ....................... 6 4.1 Main Features ..........................6 5. -
Page 3: Precautions
WARNING: Ecler products have a long lifetime of more than 10 years. This product must never be discarded as unsorted urban waste, but must be taken to the nearest electrical and electronic waste treatment centre. -
Page 4: Key Safety Directions
1.2 Key Safety Directions Read the following directions. 11. Only use attachments/accessories specified by the manufacturer. Keep the following directions. 12. Unplug the device during lightening Heed all warnings. sorts or when unused for long periods of Follow all directions. time. -
Page 5: Warranty & Environment
Recycling materials and using non-contaminant components are also top priorities in our green crusade. Ecler has deeply evaluated and analyzed the environmental impacts of all the processes involved in the production of this product, including packaging, and has alleviated, reduced and/or compensated for them. -
Page 6: Description & Features
4. DESCRIPTION & FEATURES SAMI-603 is an installation audio mixer in standard rack format, featuring 1 MIC input + 4 MIC/LINE Stereo inputs + 1 LINE Stereo input and 3 outputs that can be configured as 1 stereo couple + 1 mono or 3 independent mono. -
Page 7: Install & Connect
The SAMI-603 mixer has been specially designed to be installed in a standard 19" rack, taking up 1U. Due to its low power consumption and heat sink, the SAMI-603 does not need any fan cooling. However, avoid installing it in dusty environments and/or in a location with extreme temperature and moisture. -
Page 8: Start-Up & Operation
6. START-UP & OPERATION 6.1 Connections 6.1.1 Inputs The SAMI-603 inputs accept two types of audio signals (mono microphone and/or stereo line). For inputs accepting both types of signals, the selection is done using a MIC/LINE switch located on the rear panel. - Page 9 CD and LINE sources and other devices capable of producing audio signals, the LINE inputs 2-5 of the SAMI-603 are standard line inputs (0dBV) and the sensitivity of the LINE input #6 can be selected (0/-6dBV) by internal jumper (the default position is 0dBV). A sensitivity of -6dBV is ideal for low-level sound sources such as media players, portable MP3 players, tablets, computers, mobile phones, etc.
-
Page 10: Outputs
6.1.2 Outputs SAMI-603 has three electronically balanced outputs with Euroblock connectors Connection is made according to the following diagram: The master level of each mixer output (OUT A, B or C) must be adjusted so that the overload indicators (CLIP) are not permanently lit on the system amplifiers, but at most on the lowest frequencies marking the rhythm. -
Page 11: Other Connections On The Back Panel
6.1.3 Other connections on the back panel 1. AUX/REC output with a nominal output of 0dBV (10kΩ load) and an extra gain setting of +6dB, enabled by internal jumper (0dBV is the default position). Please note that the “Output Sensitivity” selector always affects the main output. -
Page 12: Starting-Up
Plug the external PSU to the DC IN connector located on the rear panel and then, after connecting it to the power outlet, press the on/off switch to power the unit. Even the power-up noise of SAMI-603 is minimal, we highly recommend to power up all equipment in the following order: 1. -
Page 13: Mono/Stereo Modes And Inputs-Outputs Assignment
6.3 Mono/Stereo modes and Inputs-Outputs assignment On the front panel, each input channel has a master level control (VOL) and 3 buttons (A, B and C) to assign its signal to one or more outputs of the unit. When one of these buttons is engaged, the signal is sent to the corresponding output. -
Page 14: Equalization
Cable shields, when connected to the chassis, must never be linked together. This will avoid ground loops. The SAMI-603 mixer has been designed to produce the lowest background noise. Independently from the electronic design, the resulting background noise directly relies on the correct use and installation of the mixing unit. -
Page 15: Panel Functions
7. PANEL FUNCTIONS 7.1 Front Panel Channel volume control, VOL x6 Midrange control, MID x2 Talkover switch, tk x5 Treble control, TREBLE x2 Output destination switches, A, B, C LED indicator, SP/CLIP x3 STEREO (VOL A) /SINGLE (VOL A / Output main volume control, OUT A / VOL B) Switch B / C... -
Page 16: Technical Data
8. TECHNICAL DATA 8.1 Technical Specifications SAMI-603 ANALOGUE AUDIO INPUT PORTS Number of input ports 4, MIC/LINE 1, MIC 1, LINE STEREO Connection type MIC: 3-pin Euroblock LINE: RCA Input sensitivity LINE 2-5: 0dB LINE 6: 0dB/-6dB (internally selectable) MIC 1-5 BAL: -35dB Input sensitivity adjust MIC/LINE: ±15dB... - Page 17 Status Indicators Power ON LED, MUTE LED, SP/CLIP LEVEL LED REMOTE CONTROL CONNECTIONS GPIs MUTE control port NO/NC ELECTRICAL Power supply ±17.5VDC External PSU AC mains requirement 100-240 V @ 50-60Hz (External PSU: 17.5VDC) AC mains connector IEC inlet connector Power consumption 13.9VA / 6.3W Cooling Passive PHYSICAL...
-
Page 18: Mechanical Diagram
8.2 Mechanical Diagram All measurements in mm. - Page 19 NEEC AUDIO BARCELONA S.L. reserves the right to make changes or improvements in the design or manufacturing that may affect these product specifications. For technical queries contact your supplier, distributor or complete the contact form on our website, Support / Technical requests. Motors, 166‐168 08038 Barcelona, Spain Tel. (+34) 932238403 information@ecler.com www.ecler.com...
Need help?
Do you have a question about the SAMI-603 and is the answer not in the manual?
Questions and answers