Default Q-Link Mode; Bypassing Default Q-Link - Akai MPC5000 Manual Addendum

Music production center

Hide thumbs Also See for MPC5000:

Table of Contents

Default Q-LINK Mode

In Q-LINK Mode, the Q-LINK Controllers always work as PROGRAM Q-

LINKs or FX Q-LINKs, depending on which page is selected.

outside of Q-LINK mode, you can determine which type of Q-LINKS are

used by default.

To set the default Q-LINK Mode, do the following:

01. In Q-LINK mode, press [F3] (SETUP)

02. Set the 'Default Q-LINK Mode' to the desired setting

PROGRAM

Outside of Q-LINK mode, a Q-LINK will control the corresponding

Program Q-LINK

EFFECT

Outside of Q-LINK mode, a Q-LINK will control the corresponding EFFECT Q-LINK

Tip: when in the PGM Q page, the Q-LINKS will always affect the program, and while in FX Q, the Q-LINKS will always affect

the effects regardless of this setting.

The Default Q-LINK Mode can be bypassed temporarily by moving a Q-LINK Controller while holding the [SHIFT] key.

When

Table of Contents