Miniatures Martin's Market Stall Kit Step By Step Assembly Instructions

#42023 Martin's Market Stall Kit
Step-by-step assembly instructions
Copyright miniatures.com 2022, 2024
MDF PARTS:
Base (B)
Left Wall (LW)
Right Wall (RW)
Front Wall (FW)
Back Wall (BW)
Right Roof (RR)
Left Roof (LR)
WHITEWOOD PARTS:
Ridge Beam (RB)
SUPPLIES NEEDED:
Masking tape
White glue (such as #1249 Weldbond)
Damp clean cloth
Exterior and interior finishes
Assembly Instructions
Tip: Plan the finishes for the interior and exterior at the
dry-fit stage, before final/permanent assembly. It is easier
to finish the panels as flat surfaces. Disassemble and
finish as desired, then reassemble using glue.
1. Locate the Base (B) and the Left Wall (LW).
2. Orient the Left Wall (LW) so that the groove is at the bot-
tom facing inwards and the bevel is at the top facing out-
wards. The Left Wall (LW) and Base (B) will be flush along
both front and back edges.
3. Glue the Left Wall (LW) to the Base (B) at the groove.
4. Secure in place with tape (or clamps).
5. Use a damp clean cloth to wipe away any excess glue.
6. Locate the Right Wall (RW).
7. Orient the Right Wall (RW) so that the groove is at the
bottom facing inwards and the bevel is at the top facing
outwards. The door will be to-
wards the back. The door sill
will be flush with the Base (B).
The Right Wall (RW) and Base
(B) will be flush along both
their front and back edges.
8. Glue the Right Wall (RW) to the
Base (B) at the groove.
2388 Pleasantdale Road, Atlanta, GA 30340 • 1.800.926.6464 • www.miniatures.com • Made in Thailand
GENERAL INSTRUCTIONS
• Identify and inspect all parts using the Parts List and Parts Diagram.
• Thoroughly read the directions before starting.
• Set up a dedicated work area to avoid the need to unpack,
repack, or move the project frequently.
• Use a clean, level, and dry work surface protected from glue spills.
• Dry fit the parts using masking tape to ensure everything aligns
correctly before permanent assembly.
9. Secure in place with tape (or clamps).
10. Use a damp clean cloth to wipe away any excess glue.
11. Pivot the assembly onto its back.
Check for correct orientation by con-
firming that the door is closest to the
back.
12. Locate the Front Wall (FW).
13. Glue the Front Wall (FW) to the front
of the assembly.
Assure the bottom edge of the
Front Wall (FW) is flush with the Base
(B). Then gently adjust the tops of
the Right Wall (RW) and Left Wall (LW) in or out to square
them to the Front Wall (FW).
14. Use a damp clean cloth to wipe away any excess glue.
15. Secure in place with tape (or clamps).
16. Pivot the assembly onto its front. Check again for correct
orientation by confirming that the door is furthest from
the Front Wall (FW).
17. Locate the Back Wall (BW) and the Ridge Beam (RB).
18. Glue the Back Wall (BW) to the back of the assembly.
Assure the bottom edge of the Back Wall (BW) is flush with
the Base (B). Then gently adjust the tops of the Right Wall
WARNING:
Not Suitable for Children
under 15 years old.
CHOKING HAZARD — Small parts
0824