Miniatures Shaker Kitchen Upper Corner Cabinet Kit Step By Step Assembly Instructions

#15010 Shaker Kitchen –
Upper Corner Cabinet Kit
Step-by-step assembly instructions
Copyright miniatures.com 2024
SUPPLIES NEEDED:
Masking tape
White glue (such as #1249 Weldbond)
Damp clean cloth
Finishes
Assembly Instructions
Place both Backs on the work surface side by side
1.
with their beveled edges facing down and touching.
Add tape across where the two pieces join.
2. Turn the assembly over and add glue to the beveled
edges. Close the pieces together and stand them up
like a book. Support the joint by adding tape across
the corners. Clean away excess glue inside the joint.
3. Orient the assembly with the smallest shelf space
towards the top.
4. Glue the Large Shelf on the right
side and into the center groove.
5. Glue the L-Shelves into the top
and bottom rabbets. Set aside.
6. Glue the Smaller Shelf to the
groove on the Dividing Wall.
7. Glue this assembly to the left side of the cabinet
assembly between the L-Shelves. The Diving Wall
touches the Large Shelf. All joints are flush.
8. Glue the Sides to the outside edges
of the Shelves and Backs. Orient
their rabbets towards the back. All
joints are flush.
9. Glue the Long Trim to the front
edges of the Sides. They go flush at
the top edges.
10. Glue on the Shorter Trim. They go
on the front edges of the top and bottom Shelves and
are flush against the Long Trim. Assure that the hinge
holes are oriented towards the
outer edges.
11. Assemble and install the doors.
12. Glue the Corner Trim to the inner
corner. It is flush with the top and
bottom L-Shelves.
13. Finish as desired.
Assembly is now complete. Enjoy!
2388 Pleasantdale Road, Atlanta, GA 30340 • Tel 1.800.926.6464 • www.miniatures.com • Made in Thailand
Not Suitable for Children
under 15 years old.
GENERAL INSTRUCTIONS
• Identify and inspect all parts using the Parts Diagram.
• Read the directions completely before beginning the
project.
• If possible, have a dedicated work area so that you are
not unpacking, repacking, and moving the project from
place to place.
• Choose a work surface that is level, clean, dry, and
protected from glue spills.
• Do a dry fit, using masking tape to hold parts in place,
to make sure everything fits together correctly before
assembling permanently.
Tips:
•
The kit is precisely cut to fit together with minimal
sanding, if any. Where needed, use a fine grit paper on
a sanding block.
•
A fine-tipped glue applicator (such as the Pinpoint
Glue Syringe Kit #10244) can be helpful.
•
Stain the cabinets before assembly or paint after
assembly.
•
All drawers in the collection fit together the same way.
The sides attach around the base. All outside edges
are flush. Fronts have two predrilled holes for hardware;
they are flush at the bottom edge and rises above the
drawer.
•
All doors in the collection fit together the same way.
The door framing fits around the door panel and the
back is flat. The frame piece that is contoured and has
a hole at either end goes on the hinge side. The hole
on the surface of a frame piece is for the pull. Pulls are
at the top for lower cabinets and the bottom for upper
cabinets.
•
To install door hinges, insert one pin in the hole at the
top or side of the frame. Push the pin through and into
the corresponding hole in the door. Adjust the door
alignment as necessary for the holes to align. Insert
another pin through on the other end.
WARNING:
CHOKING HAZARD — Small parts
1024