moss DESIGN MA Quick Start Manual

Coffee table

Download this manual

Placement and Maintenance

Your Ma Coffee Table is designed for indoor use on level

floors. Furniture with hard lacquer, wax polish or painted

surface should be dusted with a dry cloth. Spillages should

be wiped up as soon as possible. Our furniture will endure

most temperatures in the home but it is best to avoid placing

furniture next to heat sources such as radiators or fires.

Step 1

Unpack and identify all the parts listed here. It is necessary

to have two people to carry and assemble units weighing

over 50 lbs. The assembly workspace should be a

non-marring surface, such as a carpet. For missing hardware

pieces, visit our website www.mossdesign.us

COFFEE TABLE

Tool Required:

Mallet

Tool Provided:

T1 M4 Allen Key x 1

H1 Bolt

(6x16mm) x 16

H2 Wooden Dowel

(8x35mm) x 2

H3 Bolts

(6x70mm) x 4

H4 Metal Bracket x 4

C1 Top Panel x 1

C2 Leg Frame x 1

C3 Leg Frame x 1

YNG.TAL.14 / AMBJ001385

Need help?

Do you have a question about the MA and is the answer not in the manual?

Page 1 COFFEE TABLE Tool Required: Mallet Placement and Maintenance Your Ma Coffee Table is designed for indoor use on level floors. Furniture with hard lacquer, wax polish or painted Tool Provided: surface should be dusted with a dry cloth. Spillages should T1 M4 Allen Key x 1 be wiped up as soon as possible.
Page 2 Step 2 - Attach the metal brackets. Attach 4 metal brackets H4 onto the leg frames by using the allen key T1. Step 3 - Insert the wooden dowels Insert 2 wooden dowels H2 into their slots on the leg frame C2 by using a mallet.
Page 3 Step 4 - Place the leg on the top panel. Place the leg frame C2 under the top panel C1 as shown below. Then insert 2 bolts H3 into their slots and tighten with the allen key T1. Step 5 - Attach the metal brackets. Attach the metal brackets to the top module by using 4 bolts H1 and the allen key T1.
Page 4 Step 6 - Attach the second leg frame. Place the leg frame C3 on the top module C1 as shown below. Then insert the 2 bolts H3 into their slots and tighten with the allen key T1. Step 7 - Attach the metal brackets. Attach the metal brackets to the top module by using 4 bolts H1 and the allen key T1.
Page 5 Step 8 - End of the assembly. Lift the unit to standing position carefully. Moss Design is a trade name of a Colorado company Moss Furniture LLC www.mossdesign.us...