Dell Precision 410 Service Manual page 55

System halted
Terminator/
processor card
not installed!
System halted!
Time-of-day
clock stopped
Time-of-day not
set
Timer chip
counter 2
failed
WARNING: Dell's
Disk Monitor-
ing System has
detected that
drive [0/1] on
the [0/1] EIDE
controller is
operating out-
side of normal
specifica-
tions. It is
advisable to
immediately
back up your
data and
replace your
hard-disk drive
by calling your
support desk or
Dell Computer
Corporation.
Write fault
Write fault on
selected drive
FRQWLQXHG
System locked up
because the processor
is not the correct
revision.
System does not have
terminator card or
secondary processor.
System battery is low.
Time or Date settings in
System Setup program
are incorrect, or the sys-
tem battery does not
work.
Timer circuit on system
board is malfunctioning.
POST queried EIDE
drive for status. Drive
detected possible error
conditions.
MS-DOS cannot write
to diskette or hard-disk
drive.
Beep Codes and Error Messages
System processor is not
a type supported by Dell
and more than 512 MB of
RAM is installed.
Terminator card or
secondary processor is
improperly installed or is
not installed.
Defective battery or
faulty chip (defective sys-
tem board).
Incorrect Time or Date
settings, or defective sys-
tem battery.
Defective system board.
Unreliable or defective
drive.
Faulty diskette or hard-
disk drive.
3-11