Dell Precision 410 Service Manual page 50

3-6 Dell Precision 410 Systems Service Manual
Alert! Proces-
sor thermal
probe failure
detected.
Alert! Second-
ary processor
is out of rev.
Alert! Single-
bit memory
error previ-
ously detected
in XXXXh.
Alert! System
fan was not
detected.
Alert! Unbuf-
fered and
registered
SDRAM DIMMs
cannot be
mixed.
Alert! Uncor-
rectable memory
error previ-
ously detected
in XXXXh.
Auxiliary
Device fail-
ure. Verify
that mouse and
keyboard are
securely
attached to
connectors.
Bad command or
file name
FRQWLQXHG
Processor or
system board has
failed.
System detected that
the secondary proces-
sor is not the correct
revision. If the system
contains more than
512 MB of RAM, this
message will be fol-
lowed by a System
Halted message.
Single-bit ECC error
was detected during
the previous operating
session.
System fan was not
detected.
Mixing of unbuffered
and registered SDRAM
DIMMs is not
supported.
Multibit ECC error was
detected during the pre-
vious operating session.
System detected a
mouse failure.
Command entered
does not exist, is faulty,
or is not in pathname
specified.
Faulty processor or
defective system board.
Processor is a type not
supported by Dell.
Faulty or improperly
seated DIMMs or defec-
tive system board.
No fan installed, defec-
tive fan, or fan cable not
connected.
Two different types
(unbuffered and regis-
tered) of SDRAM DIMMs
have been installed
together and may not be
compatible.
Faulty or improperly
seated DIMMs or defec-
tive system board.
Faulty mouse, or faulty
mouse controller or key-
board is attached to the
mouse connector.
Faulty command and syn-
tax, or incorrect filename.