Dell Precision 410 Service Manual page 49

Address mark
not found
Attachment
failed to
respond
Alert! Cover
was previously
removed.
Alert! Hard
disk drive
thermal probe
failure
detected.
Alert! One or
more of the
Memory DIMMs
are out of rev.
Alert! Power
supply fan
failure
detected.
Alert! Previ-
ous fan
failure.
Alert! Previ-
ous thermal
failure.
Alert! Previ-
ous voltage
failure.
Alert! Primary
processor is
out of rev.
BIOS found faulty disk
sector or could not find
particular disk sector.
Diskette drive or hard-
disk drive controller
cannot send data to
associated drive.
Cover was previously
removed.
Hard-disk drive thermal
probe has failed.
System detected that
one or more of the
DIMMs are not the cor-
rect revision.
Power supply fan has
failed.
System fan failed during
the previous operating
session.
The microprocessor
exceeded its recom-
mended operating
temperature during the
previous operating
session.
System voltage
exceeded or fell below
an acceptable
threshold.
System detected that
the primary processor is
not the correct revision.
If the system contains
more than 512 MB of
RAM, this message will
be followed by a Sys-
tem Halted message.
Beep Codes and Error Messages
Faulty diskette/tape drive
subsystem or hard-disk
drive subsystem (defec-
tive system board), faulty
interface cable or
connector.
Cover was previously
removed.
No hard-disk drive
thermal probe installed,
defective thermal probe,
or thermal cable not con-
nected to the control
panel.
DIMMs do not meet
Intel's SPD 1.2 specifica-
tion or 66-MHz DIMMs
are installed.
The power supply or sys-
tem board is defective.
No fan installed, defec-
tive fan, or fan cable not
connected.
Operating environment is
too hot (above 35 C). The
system vents may be
blocked, causing the sys-
tem to overheat.
Defective power supply.
Processor is a type not
supported by Dell.
3-5