Dell Precision 410 Service Manual page 116

A-6 Dell Precision 410 Systems Service Manual
7DEOH $ 6\VWHP 6HWXS &DWHJRULHV
&DWHJRU\
Parallel Mode
IDE Hard Disk
Diskette
Speaker
SCSI
System Data
Microprocessor
CPU ID
Level 2 Cache
System Memory
Service Tag
Asset Tag
FRQWLQXHG
)XQFWLRQ
Controls whether the system's built-in parallel
port acts as an AT-compatible (unidirectional)
or PS/2-compatible (bidirectional) port. The
system also supports ECP mode for
Windows 95.
Enables the system's built-in EIDE hard-disk
drive interface.
Enables the system's built-in diskette
controller.
Determines whether system sounds (other
than beep codes) are emitted by the on-board
speaker.
Controls the system's built-in SCSI controllers.
SCSI settings are Off (default), Secondary
Only, Primary Only, and Primary and
Secondary.
These fields display information about the sys-
tem. They are not selectable.
Displays the type and speed of the micro-
processor(s) installed in the computer.
Displays the ID number of the microprocessor.
This information can help Dell technical
assistance engineers identify which version of
microprocessor is installed in the computer.
Displays the size of level-2 cache memory in
the microprocessor.
Displays the entire amount of installed
memory detected in the system, except for
memory on EMS expansion cards.
NOTE: After adding memory, check System
Memory to confirm that the new memory is
installed correctly and is recognized by the
system.
Displays the system's five-character service
tag number.
Displays the customer-programmable asset
tag number up to ten characters if one is
assigned.