Rampage 1285300F Owner's Manual page 8

button is pressed momentarily, tuning will
occur two frequency steps at a time. If either
button is pressed and held in Manual mode
for 2 seconds, the manual Seek Tuning func-
tion is initiated, whereby the radio will tune
rapidly in the appropriate direction and stop
on, or close to, the desired frequency when
the button is released.
If no further tuning is performed after 5 sec-
onds, AUTO will appear momentarily on the
display, and tuning will revert to the original
tuning mode.
AUTO-STORE TUNING (AS)
PRE-SET SCAN TUNING (PS)
Press this button momentarily to scan the 6
stations in the pre-set memories of the FM
band in use, plus the other two FM bands.
The unit will stop at each pre-set station for
10 seconds before continuing to the next
pre-set station (the frequency on the display
panel will flash during Pre-Set Scan opera-
tion). Press the button again momentarily
to stop Pre-Set Scan operation and remain
on the selected frequency in that band.
Pressing the button for longer than 2 sec-
onds will activate the Auto-Store Tuning fea-
ture. The radio will automatically scan the
band in use and enter strong stations into
the pre-set memory positions for that band.
If you have already set the pre-set memo-
ries of that band to your favorite stations,
activating the Auto-Store Tuning feature will
erase those stations and enter the new
strong stations. This feature is most useful
when traveling in a new area where you are
not familiar with the local stations.
STATION PRE-SET MEMORIES
To set any of the 6 pre-set memory buttons, use
the following procedure:
8 8 8 8 8
1. Turn the unit on and select the desired
band.
2. Select the first station to be pre-set using
the Up/Down seek/tuning functions
3. Press the pre-set button to be set and con
tinue to hold the button in. A confirming tone
will be heard and the pre-set number will ap
pear on the display panel. The station is now
set into the memory of that pre-set button and
can be re-called at any time by momentarily
pressing that button.
4. Repeat the above procedure for the remaining
5 pre-sets on the band in use and for the other
3 bands of the unit.
EQUALIZER SELECTOR (EQ)
The EQ button applies preset sound effects to the
unit's audio output signal. The EQ button, when
pressed, will activate one of the following operat-
ing modes: CLASSICS, POP M, ROCK M, FLAT,or
DSP OFF. Nonetheless, when the EQ function is
active, as displayed ( EQ ----CLAS, POP, ROCK)
on the panel, the bass and treble levels can still
be changed to accommodate the listener's ear.
When the EQ function is not active, the unit re-
turns to the user-set bass and treble levels. The
FLAT selection indicates no equalizer enhance-
ment of the program, thereby removing the pre-
set sound effects, unless otherwise desired,
while DSP OFF inhibits selection of equalizer
mode enhancement.
FM MONO/STEREO SELECT (MONO)
During FM radio operation, this button is used to
select monaural or stereo reception of the
broadcast signal. Under normal reception
conditions, the unit should be left in the stereo
mode as indicated by the
panel when tuned to an FM stereo signal. If the
signal is to noisy for comfortable listening, press
the MONO button (the
disappear from the display panel and MONO will
appear).To return to stereo reception mode, press
the button again so that the
appears on the display panel.
bm
.
icon on the display
indication will
indication