Error Codes - Rampage 1285300F Owner's Manual

1. Switch the vehicle ignition "on" and the radio "on" (radio frequency or disc track num-
ber will be shown on the display panel).
2. Momentarily press the Time/Frequency (T/F) button to display the time of day. Then
press and hold the T/F button until the time display flashes.
3. While the display is flashing, press the Up Tuning button (
hours and the A or P indication, and the Down Tuning button (
utes to the correct time.
4. When the correct time is shown on the display panel, press and release the T/F button
(or wait 5 seconds) for the display to return to the normal indication.
If a problem should develop while operating the CD player, the following error codes
may be displayed on the display panel:
ER-2: Indicates the disc is not loading properly. Try re-loading or pressing the
Eject button. Check the condition of the disc in use or try another disc.
ER-3: Indicates the disc is not ejecting properly. Try pressing the Eject button
again. Check the condition of the disc in use or try another disc.
ER-4: Indicates an error in the laser reading the disc. Eject the disc, make sure
it is clean, undamaged, and loaded correctly (label side up). Re-load the
disc and check for proper operation or try another disc.
ER-5: Indicates excessive temperature conditions. CD play will resume when
the temperature returns to the normal range.
ER-6: Indicates a mechanism error. Eject the disc and try re-loading. Also try
activating the RESET button
ER-7: Indicates an error in the laser reading the disc. Eject the disc, make sure
it is clean, undamaged, and loaded correctly (label side up). Re-load the
disc and check for proper operation or try another disc.
ER-8: Indicates an error in the laser reading the disc. Eject the disc, make sure
it is clean, undamaged, and loaded correctly (label side up). Re-load the
disc and check for proper operation or try another disc.
If the suggested measures do not solve the problem, contact an approved warranty
12 12 12
12 12
station near you for further assistance.
SET T T T T T ING THE CLOCK SET SET ING THE CLOCK ING THE CLOCK ING THE CLOCK
SET SET ING THE CLOCK

ERROR CODES

ERROR CODES
ERROR CODES ERROR CODES ERROR CODES
cu
and try again.
) to adjust the
) to adjust the min-