Subscribe to Our Youtube Channel
Related Manuals for WAREMA Light well cover
Summary of Contents for WAREMA Light well cover
- Page 1 WAREMA Insect screens Light well cover Instructions for installation, use and maintenance To be handed over to the user Valid from 08 February 2007 Document number [B866295_1] – EN...
-
Page 2: Introduction
It is important to follow these instructions in the interests of personal safety. Failure to comply with these instruc- The WAREMA Light well cover must mounted directly to tions when operating the product may result in property the existing grids. Any other installation can lead to inju- damage and/or personal injury. -
Page 3: Table Of Contents
General safety information ....................4 Transport........................... 4 Scope of delivery....................... 5 Tools and aids........................5 Installation ......................... 5 Unpacking the Light well cover........................5 Installing the Light well cover........................... 5 For tilting dowel attachment..........................6 Care ..........................8 General information on care ..........................8 Cleaning the Light well cover.......................... -
Page 4: Product Information
If technical qualifications for installing the prod- uct are not available, have the product installed by a specialist. Improper installation will dama- ge the WAREMA Light well cover. Type 812 DANGER Risk of injury and damage to the product from... -
Page 5: Scope Of Delivery
2.9x6.5 Fig. 2: Attaching the L-shaped angle Attach the L-shaped angle (4) though existing drill holes on the Light well cover (1) using countersunk head tapping screws (4)! [B866295_1] - EN / 07.02.07 Page 5 of 8 Subject to change without notice. -
Page 6: For Tilting Dowel Attachment
To achieve an optimum adhesive effect of the rubber tape, the surface of the grid (1) may not be dirty. Hold the Light well cover (1) at the desired position! Clean dirt off the grid of the light well or air duct! - Page 7 Stainless steel gauze Fig. 7: Installing the tilting dowel Lay the Light well cover above the grid (3)! Conduct the wings (2) of the tilting dowel (1) through the opening of the grid (3) until the wings (2) of the tilting dowel (1) spread! [B866295_1] - EN / 07.02.07...
-
Page 8: Care
Dismantling and re-installation of the product must be un- dertaken in accordance with current guidelines and stan- Clean the Light well cover regularly. Follow the proce- dards. Be sure to ask the manufacturer for any missing dure described in the following table.
Need help?
Do you have a question about the Light well cover and is the answer not in the manual?
Questions and answers