Rotenso CONTROL GOTE User Manual page 7

3. You can program the temperature display between °C and °F.
1. Press and hold the
2. Press and hold the
3. Then release the button and wait 5 seconds, the function will be selected.
4. REMOTE CONTROL FUNCTIONS
1. COOLING MODE
The cooling function allows the air conditioner to cool the room and reduce Air humidity
at the same time.
To activate the cooling function (COOL), press the
appears on the display.
With the button or set a temperature lower than that of the room.
2. HEATING MODE
The heating function allows the air conditioner to heat the room.
To activate the heating function (HEAT), press the
appears on the display.
With the button or set a temperature higher than that of the room.
In HEATING operation, the appliance can automatically activate a defrost cycle, which
is essential to clean the frost on the condenser so as to recover its heat exchange
function. This procedure usually lasts for 2-10 minutes.
During defrosting, indoor unit fan stop operation. After defrosting, it resumes to
HEATING mode automatically.
3. DRY MODE (some units)
This function reduces the humidity of the air to make the room more comfortable.
To set the DRY mode, press the
function of pre-setting is activated.
4. FAN MODE (not fan button)
Fan mode, air ventilation only.
To set the FAN mode, press the
button over 5 seconds to get into the change mode
button until it switch to °C and °F;
button until
button until the
button until the
NOTE
appears in the display. An automatic
button until appears on the display.
Remote control - GOTE
symbol
symbol
User manual
EN
7